Abstract:Using cobaloxime boron fluoride (COBF) and AIBN as catalyst and initiator respectively, the catalytic chain transfer bulk polymerization of 2-hydroxyporpyl methacrylate ( HPMA) was carried out at 60 degrees C and the low molecular weight polymer with a terminal double bond was prepared. The evolution of the apparent chain transfer constant (C-S(spp)) of COBF during the polymerization was determined by the Mayo equation and the CLD (chain length distribution) equation respectively. At the beginning of the reaction the chain transfer constant showed values of up to about 2000, but with the increasing of the monomer conversion, the chain transfer constant decreases and keeps at a value of about 600 for sometime and then decreased again. The most likely cause for the catalyst deactivation is the stable cobalt-carbon bond formed at the first period of the reaction and then reached equilibrium point. When the polymerization proceeds up to middle and high conversion, the chain transfer polymerization is further manipulated by diffusions of polymeric propagating chain and catalyst molecules, and the apparent chain transfer constant fell to value of below 300. It has been found also, that the data determined by the CLD equation are usually lower than those by the Mayo equation, especially at high conversion stage. It is because that both original equations are available for the instantaneous produced polymer or the case of very lower conversion stage. However, the GPC measurements give molecular weight distributions of the cumulated products rather than the instantaneous produced polymer. The number-average polymerization degrees for the instantaneous produced polymers were obtained from the GPC data, and used in the Mayo equation method together with the modification of the monomer concentration. It was believed that the apparent chain transfer constants from the modified Mayo equation method are more available for the middle and high conversion cases.

Studies on the continuous precipitation copolymerization of acrylonitrile in aqueous medium with high monomer feed concentration: I conversion, MW and MWD

Influence of Small Amount of Co-Monomers on Acrylonitrile Polymerization in Dimethylformamide (DMF) Solution

Continuous Thermal Bulk Copolymerization of Styrene and Maleic Anhydride

Graft Copolymerization of Styrene and Acrylonitrile in the Presence of Poly(propylene Glycol): Modeling and Simulation of Semi‐Batch and Continuous Processes

Graft Copolymerization of Styrene and Acrylonitrile in the Presence of Poly(Propylene Glycol): Particle Growth

Semicontinuous thermal bulk copolymerization of styrene and maleic anhydride: Experiments and reactor model

Effects of acrylonitrile water solubility on limiting conversion and copolymer composition in suspension polymerization

Monte Carlo simulation of molecular weight distribution and copolymer composition in transamidation reaction of polyamides

THE EVOLUTION OF THE CHAIN TRANSFER CONSTANT DURING THE CATALYTIC CHAIN TRANSFER POLYMERIZATION OF 2-HYDROXYPROPYL METHACRYLATE

STUDIES ON COMPOSITION OF COPOLYMERS IN VINYLIDENE CHLORIDE-ACRYLONITRILE SUSPENSION COPOLYMERIZATION

Effect of Ph Value on the Aqueous Precipitation Copolymerization of Acrylonitrile and Vinyl Acetate

Studies on Anionic Continuous Solution Copolymerization of Butadiene/Styrene with N-Buli Initiator

Effects Of Water Solubility Of Acrylonitrile On Vinylidene Chloride/Acrylonitrile/Styrene Suspension Polymerization

KINETICS OF SUSPENSION COPOLYMERIZATION OF VINYLIDENE CHLORIDE WITH ACRYLONITRILE

KINETICS OF ACRYLAMIDE POLYMERIZATION IN POLYETHYLENE GLYCOL AQUEOUS SOLUTIONS

Synthesis and Performance of Acrylonitrile-Styrenesulfonic Acid Copolymer Proton Conducting Membrane

Ab Initio RAFT Emulsion Copolymerization of Styrene and Acrylonitrile

A Metal-Free Method for Ultra-High Molecular Weight Polyacrylonitrile under Dimethyl Sulfoxide

On-Line Study on Continuous Precipitation Polymerization of Acrylonitrile in Aqueous Medium

Study on photoinitiated precipitation polymerization of acrylamide

Study of Polymerization Conditions for Synthesizing High Molecular Weight Hydrophobically Associating Water-Soluble Polymer