Abstract:HZSM-5 zeolites with Si/Al ratios of 20, 35, 50 and 65 were prepared by the directing crystallization process of silicalite-1 seeds. The influence of Si/Al ratios on the production of benzene, toluene, xylene and naphthalene (BTXN) originated from asphaltenes catalytic pyrolysis was explored by adopting Py-GC/MS. Modified Z5-50 zeolites were prepared by various metal ions (Ni2+, Mo6+, Fe3+, and Co2+) with different loading rates (3 % (mass), 5 % (mass), 7 % (mass), and 9 % (mass)) and the physical and chemical properties of these zeolites were characterized by XRD, SEM, ICP-OES, XPS, NH3-TPD, FTIR, Py-IR and N2 adsorption-desorption isotherm. In addition, they were employed to catalyze the conversion of asphaltenes pyrolysis production to BTXN using Py-GC/MS. Results show that the highest relative content of aromatics has been obtained over HZSM-5 with Si/Al ratio of 50 (Z5-50), reaching 61.87%. Besides, the loading of Ni, Mo, Fe, and Co on Z5-50 leads to an increase of acid strength and provides new active sites. The relative content of BTXN increases by 3.17% over 3Ni-Z5, which may be ascribed to that Ni promoted the conversion of polycyclic aromatic hydrocarbons (PAHs) to monocyclic aromatics due to the cracking of aliphatic side chains of PAHs and the decrease of phenolic activation energy. While under the catalysis of 5Mo-Z5, the relative content of aromatics and BTXN augmented by 5.75% and 4.02%, respectively. In addition, the highest relative content of aromatics reaches 70.09% when the loading rate of Fe was 7 % (mass), and the relative content of BTXN increases from 25.87% to 29.42%. The results demonstrate that the active sites provided by different metal species expressed diverse effects on BTXN. Although the Brønsted/Lewis acid ratios of HZSM-5 modified by metal decreased, the acid strength and the relative content of BTXN both increased, which illustrated that there is a synergistic catalysis with the Brønsted acid sites and Lewis acid sites provided by metal species. In general, the performance of the catalyst is affected by the pore structure, acidity and metal active sites. Moreover, the possible formation mechanism of BTXN derived from asphaltenes catalytic pyrolysis was proposed on the basis of structural features and catalytic performances of a series of zeolites.

Effect of the catalytic system and operating conditions on BTX formation using tetralin as a model molecule

Catalytic Hydrocracking Reactions of Tetralin Biomass Tar Model Compound to Benzene, Toluene and Xylenes (BTX) Over Metal-Modified ZSM-5 in Ambient Pressure Reactor

Morphology Dependent Relationship Between the Catalytic Performance and Zsm-5 Zeolite in Tetralin Conversion into Light Aromatics

Tetralin Hydrocracking Reaction Network to Single-Ring Aromatics on Bifunctional Catalysts

Efficient Conversion of Methane to Aromatics in the Presence of Methanol at Low Temperature

Mechanism of catalytic conversion of kerosene co-refining heavy oil to BTEXN by Py-GC/MS based on "point-line-surface-body" step by step research strategy

Zeolite domination in coordination between metal and acid sites on an industrial catalyst for tetralin hydrocracking

Identifying the Location of Real Active Sites in ZSM-5 Zeolites for Tetralin Conversion into Light Aromatics

Combined dealkylation and transalkylation reaction in FCC condition for efficient conversion of light fraction light cycle oil into value-added products

Co-hydropyrolysis of Pine and HDPE over Bimetallic Catalysts: Efficient BTEX Production and Process Mechanism Analysis

Enhanced Bio-BTX Formation by Catalytic Pyrolysis of Glycerol with In Situ Produced Toluene as the Cofeed

Integration of Nano-Sized HZSM-5 with ZnZrO x as a Bifunctional Catalyst to Boost Benzene Alkylation with Carbon Dioxide and Hydrogen

Efficient conversion of benzene and syngas to toluene and xylene over ZnO-ZrO2&H-ZSM-5 bifunctional catalysts

Catalytic Steam Reforming of Biomass Tar Model Compounds with Low Cost Catalysts: Effect of Operation Conditions

Performance of Bifunctional ZnZr/ZSM-5 Catalysts in the Alkylation of Benzene with Syngas

Preferential Synthesis of Toluene and Xylene from CO 2 Hydrogenation in the Presence of Benzene through an Enhanced Coupling Reaction

Examination of Key Factors Determining the Catalytic Performance of Zn-Ga/HZSM-5 Bifunctional Catalysts and Establishment of Reaction Network in Alkylation of Benzene with Carbon Dioxide

Alkylation of Benzene by Methanol: Thermodynamics Analysis for Designing and Designing for Enhancing the Selectivity of Toluene and Para -Xylene

High Metal–Acid Balance and Selective Hydrogenation Activity Catalysts for Hydrocracking of 1-Methylnaphthalene to Benzene, Toluene, and Xylene

Catalytic conversion of asphaltenes to BTXN using metal-loaded modified HZSM-5

Effects of the controllable mesostructure of nano-sized ZSM-5 on the co-cracking of phenolic bio-oil model compounds and ethanol