Abstract:Abstract A power surge is a frequent phenomenon that occurs in electronics. Inadequate and improper cooling during power surges results in a rapid increase in operating temperatures that may lead to failure of the electronics. In the present investigation, the thermal characteristics of a phase change material (PCM)-based heat sinks, having different configurations and orientations of fins, subject to (i) constant heat load and (ii) heat load with a power surge, are studied numerically. Preliminary investigations showed that a heat sink with PCM gets heated at a much lower temperature than an air cooled heat sink. Following this, four finned heat sinks are considered for further investigations. The heat sink with PCM, sans fins, is used for baseline comparison. The orientation of fins in the other four heat sinks is either vertical or horizontal with square and rectangular cross sections. The heat sink and fins are made of aluminum, and the PCM used is n-eicosane (C20 H42). The enthalpy-porosity method is used to model the solid–liquid phase change in the PCM. All the transient three-dimensional numerical simulations are carried out using ansys fluent 15.0. For a constant heat load of 5 W and power surges of various magnitudes at different time instants, the heat sink with vertical square fins shows superior performance. However, the performance variation among the heat sinks with different fin configurations is insignificant for constant heat load. Even so, for power surges, the location and the configuration of fins have a significant effect on the heater temperature. Cases with high power surge and shorter duration of the surge were also considered to critically examine the effect of fins in controlling the maximum temperature in the heat sink. The numerical results of the best-performing heat sink, i.e., the heat sink with vertical square fins, are finally validated against in-house experiments.

Experimental and Numerical Investigations on a Phase Change Material Based Heat Sink with Symbiotically Joined Heat Pipe

Experimental and numerical investigation of solid-solid phase change material assisted heat sink with integrated heat pipe for electronic cooling

Effect of phase change temperatures and orientation on the thermal performance of a miniaturized PCM heat sink coupled heat pipe

Experimental Study on the Thermal Characteristics of a 3D Thermosyphon Heat Sink

An experimental study for thermal management using hybrid heat sinks based on organic phase change material, copper foam and heat pipe

Investigation of Phase Change Material Integrated With High Thermal Conductive Carbon Foam Inside Heat Sinks for Thermal Management of Electronic Components

Thermal Performance of a Phase Change Material-Based Heat Sink Subject to Constant and Power Surge Heat Loads: A Numerical Study

Enhancement of Nanoparticle-Phase Change Material Melting Performance Using a Sinusoidal Heat Pipe

Exploration of Dual-Phase Change Coupled Heat Transfer in Solar Regenerative Evaporator

Thermal performance of phase change material–based heat sink for passive cooling of electronic components: An experimental study

Numerical and experimental study of inverse natural convection heat transfer for heat sink in a cavity with phase change material

Experimental and numerical investigations on the intermittent heat transfer performance of rectangular cavity plate fin phase change material based heat sink

Thermal performance assessment of phase change material for electronic cooling: An experimental investigation

Radiative Heat Transfer to Enhance the Performance of Liquid Metal-Based Phase Change Heat Sink under Natural Convection Condition

Phase Change Material Based Heat Sinks and Its Geometry Optimization for Heat Transfer Enhancement

An experimental study of a novel integrated heat pipe-heat sink for chip cooling

Thermal performance of a PCM heat sink under different heat loads: An experimental study

Numerical investigation and optimisation of solid–solid phase change material composite-based plate-fin heat sink for thermal management of electronic package

Optimization of Heat Sink Encapsulated with Phase Change Material for High Temperature Ambient

Thermal design of a novel heat sink cooled by natural convection with phase transition in the series loop

Experimental Investigation into the Effect of Fin Shapes on Heat Dissipation Performance of Phase Change Heat Sink