Abstract:Present paper reports the thermal performance of various phase change material (PCM)‐based heat sinks during melting process for cooling of portable electronic devices through experimental investigations. Heat sink configurations include unfinned with pure PCM, finned with pure PCM, unfinned with metallic foam (MF)–PCM composite, and finned with MF–PCM composite. Paraffin wax is used as PCM, and tests have been carried out for various input heat flux values (1.3, 2.0, and 2.7 kW/m2) at different volume fractions of PCM (0, 0.50, 0.86, and 1). The effect of various parameters such as PCM volume fraction, heat sink type, and heat flux on the stretching of operating time to achieve a set point temperature (SPT) is studied. Results obtained from the current experimental investigation are compared with the existing test results. Also, unfinned heat sink without and with PCM is used for baseline comparison. The evolution and propagation of melt front inside the heat sink are studied through photographic observation. The enhancement in operating time is found to vary with the SPT and heat flux values. MF–PCM‐based heat sinks are more advantageous for higher value of input heat flux (2.0 and 2.7 kW/m2). For q″ = 1.3 and 2.0 kW/m2, four‐finned MF–PCM‐based heat sink exhibits better performance; while three‐finned MF–PCM‐based heat sink shows best performance at q″ = 2.7 kW/m2. The highest enhancement ratio of ~2.97 is obtained at 1.3 and 2.7 kW/m2 for four‐finned MF–PCM heat sink and three‐finned MF–PCM heat sink, respectively. Also, three‐finned heat sink provides higher heat transfer rate and highest thermal conductance at q″ = 2.7 kW/m2.

Effect of phase change temperatures and orientation on the thermal performance of a miniaturized PCM heat sink coupled heat pipe

Effect of the inclination angle on the transient performance of a phase change material-based heat sink under pulsed heat loads

Experimental and numerical investigation of solid-solid phase change material assisted heat sink with integrated heat pipe for electronic cooling

Investigation of Phase Change Material Integrated With High Thermal Conductive Carbon Foam Inside Heat Sinks for Thermal Management of Electronic Components

Thermal performance of a PCM heat sink under different heat loads: An experimental study

Effect of melting temperature and amount of the phase change material (PCM) on thermal performance of hybrid heat sinks

Experimental and Numerical Investigations on a Phase Change Material Based Heat Sink with Symbiotically Joined Heat Pipe

An experimental study for thermal management using hybrid heat sinks based on organic phase change material, copper foam and heat pipe

Thermal performance assessment of phase change material for electronic cooling: An experimental investigation

Thermal performance of phase change material–based heat sink for passive cooling of electronic components: An experimental study

Numerical Investigation on Thermal Performance of PCM-Based Hybrid Microchannel Heat Sinks for Electronics Cooling Application

Thermal response to periodic heating of a heat sink incorporating a phase change material

Investigation on the Melting Performance of a Phase Change Material Based on a Shell-and-Tube Thermal Energy Storage Unit with a Rectangular Fin Configuration

Experimental and numerical investigations on the intermittent heat transfer performance of rectangular cavity plate fin phase change material based heat sink

Thermal analysis of PCM-based hybrid micro-channel heat sinks: A numerical study

Phase Change Material Based Heat Sinks and Its Geometry Optimization for Heat Transfer Enhancement

A hybrid thermal management phase change material based pin-fin heat sinks under forced convection

Experimental study on heat transfer and storage of a heating system coupled with solar flat heat pipe and phase change material unit

Thermal Performance Enhancement of Phase Change Material Heat Sinks for Thermal Management of Electronic Devices under Constant and Intermittent Power Loads

Experimental and numerical study on the cooling performance of heat pipe assisted composite phase change material-based battery thermal management system

Effect of phase change materials on heat dissipation of a multiple heat source system