Stiffness prediction of 3D printed fiber-reinforced thermoplastic composites

Jin Young Choi,Mark Timothy Kortschot

DOI: https://doi.org/10.1108/rpj-11-2018-0283

2019-12-05

Rapid Prototyping Journal

Abstract:Purpose The purpose of this study is to confirm that the stiffness of fused filament fabrication (FFF) three-dimensionally (3D) printed fiber-reinforced thermoplastic (FRP) materials can be predicted using classical laminate theory (CLT), and to subsequently use the model to demonstrate its potential to improve the mechanical properties of FFF 3D printed parts intended for load-bearing applications. Design/methodology/approach The porosity and the fiber orientation in specimens printed with carbon fiber reinforced filament were calculated from micro-computed tomography (μCT) images. The infill portion of the sample was modeled using CLT, while the perimeter contour portion was modeled with a rule of mixtures (ROM) approach. Findings The μCT scan images showed that a low porosity of 0.7 ± 0.1% was achieved, and the fibers were highly oriented in the filament extrusion direction. CLT and ROM were effective analytical models to predict the elastic modulus and Poisson’s ratio of FFF 3D printed FRP laminates. Research limitations/implications In this study, the CLT model was only used to predict the properties of flat plates. Once the in-plane properties are known, however, they can be used in a finite element analysis to predict the behavior of plate and shell structures. Practical implications By controlling the raster orientation, the mechanical properties of a FFF part can be optimized for the intended application. Originality/value Before this study, CLT had not been validated for FFF 3D printed FRPs. CLT can be used to help designers tailor the raster pattern of each layer for specific stiffness requirements.

engineering, mechanical,materials science, multidisciplinary