Abstract:An optical fiber sensor presented is capable of monitoring the presence of carbon monoxide (CO) in the exhaust environment. Conventional gas sensor used to detect CO concentration is often difficult to achieve high sensitivity, selectivity, and specificity in presence of a mixture of gases. The design of this sensor using DFB LD as light source and low-cost near-infrared components, which make it suitable for using in an exhaust environment, is discussed. The sensor based on spectrum absorption principle is immune to corrosion and poison as it consists of glass and ceramic parts. By using differential construction, it can eliminate the influence of common mode interfering signals caused by the wave of LDs light intension, thermal zero shift, and zero shift of photoelectric device. A national instrument cRIO-9215 data acquisition card was used to acquire the output voltages and a Lab View virtual instrument was used to store and process data. The response of the sensor to carbon dioxide supplied from the standard gas with dry nitrogen as a balancing gas in the laboratory was performed. The experimental results indicated that the sensor has been developed to operate within an exhaust environment and have high sensitivity and stability so it does not suffer from other gases interferences. The lower limit of detection for the sensor was found to be not less than 50 ppm for CO. This can be meeting the requirement of 100 ppm which is to be poisonous to human. (C) 2010 Wiley Periodicals, Inc. Microwave Opt Technol Lett 52:2192-2195, 2010; Published online in Wiley InterScience (www.interscience.wiley.com). DOI 10.1002/mop.25469

Micro-cantilever sensors for monitoring carbon monoxide concentration in fuel cells

Detection of CrO<sub>4</sub><sup>2</sup><sup>-</sup>Using a Hydrogel Swelling Microcantilever Sensor

Ultrasensitive detection of CrO4(2-) using a microcantilever sensor.

Detection of CrO4(2-) Using a Hydrogel Swelling Microcantilever Sensor.

Improved Sensitivity of α-Fe2O3 Nanoparticle-Decorated ZnO Nanowire Gas Sensor for CO

A Fuel-Cell-Type Sensor for Detection of Carbon Monoxide in Reformed Gases

Copper Catalysis-Based Amperometric Microsensors for Carbon Dioxide Monitoring

Microbial fuel cell-based biosensor for toxic carbon monoxide monitoring

Carbon Monoxide-Resistant Hydrogen Detection: Pt–Melamine–Formaldehyde with Portable Bluetooth in Fuel Cell

Enhanced PtRu by CeO2 hollow nanofibers: Hydrogen gas sensing with CO-resistant in fuel cell

A near-infrared optical fiber sensor for carbon monoxide concentration monitoring

Tailoring CO2 detection capabilities using Co-ZnO/MoS2 nanocomposites through electrolyte concentration modulation

A carbon monoxide sensor based on single-walled carbon nanotubes doped with copper chloride

Cobalt- and Copper-Based Chemiresistors for Low Concentration Methane Detection, a Comparison Study

Room Temperature Operated Flexible La-ZnO/MWCNTs Sensor for ppb Level Carbon Monoxide Detection

High Performance Colorimetric Carbon Monoxide Sensor for Continuous Personal Exposure Monitoring.

From Ceramic Tube to Microcantilever: A New Strategy for Low Power, Fast Heating and High Integrated Metal Oxide Semiconductor Gas Sensor

Facile wet chemical synthesis of Al doped CuO nanoleaves for carbon monoxide gas sensor applications

Tailoring the surface morphology of nanostructured cobalt oxide for high-sensitivity CO sensor

Development of MEMS gas sensors equipped with metal organic frameworks

Carbon Monoxide (CO) Sensor Based on Au Nanoparticles Embedded in a CuO Matrix by HR-LSPR Spectroscopy at Room Temperature