Abstract:Palladium has long been explored for use in gas sensors because of its excellent catalytic properties and its unique property of forming hydrides in the presence of H2. However, pure Pd-based sensors usually suffer from low response and a relatively high limit of detection. Palladium nanosheets (PdNS) are of particular interest for gas sensing applications due to their high surface area and excellent electrical conductivity. Here, we demonstrate the design and fabrication of low-cost PdNS-based dual gas sensors for room-temperature detection of H2 and CO over a wide concentration range. We fabricated sensors using multiwalled carbon nanotube@PdNS (MWCNT@PdNS) composites and compared their performance against pure PdNS devices for hydrogen sensing based on electrical resistive response. Devices using PdNS alone had a response and response time of 0.4% and 50 s, respectively, to 1% H2 in air. MWCNT@PdNS (1:5 mass ratio) showed enhanced performance at a lower hydrogen concentration with a limit of detection (LODH2) of 5 ppm. Nearly an order of magnitude increase in response was observed on increasing the amount of MWCNT to 50 mass % in the nanocomposite, but the response fell off at low H2 concentration. Overall, these PdNS-based sensors were found to show good repeatability, stability, and performance under humid conditions. Their response was selective for H2versus CH4, CO2, and NH3; the response to CO was comparable in magnitude but opposite in sign to the response to H2. Upon simultaneous exposure to equal concentrations (10 ppm each) of H2 and CO, the response to CO was dominant. The PdNS showed high sensitivity to CO, detecting as little as 1 ppm CO in air at room temperature. The sensitivity to CO could be used either in a stand-alone room-temperature CO detector, where H2 is known not to be present, or in combination with CO and combustible gas detectors to distinguish H2 from other combustible gases.

Carbon Monoxide-Resistant Hydrogen Detection: Pt–Melamine–Formaldehyde with Portable Bluetooth in Fuel Cell

Prediction of Impurities in Hydrogen Fuel Supplies Using a Thermally-Modulated CMOS Gas Sensor: Experiments and Modelling

Enhanced PtRu by CeO2 hollow nanofibers: Hydrogen gas sensing with CO-resistant in fuel cell

Dual-function Glucose and Hydrogen Peroxide Sensors Based on Copper-embedded Porous Carbon Composites

Photoacoustic Heterodyne CO Sensor for Rapid Detection of CO Impurities in Hydrogen

Micro-cantilever sensors for monitoring carbon monoxide concentration in fuel cells

A Fuel-Cell-Type Sensor for Detection of Carbon Monoxide in Reformed Gases

Cobalt Nanoparticles and Atomic Sites in Nitrogen-Doped Carbon Frameworks for Highly Sensitive Sensing of Hydrogen Peroxide.

Metal Nanocluster—Metal Organic Framework—Polymer Hybrid Nanomaterials for Improved Hydrogen Detection

High-concentration Nafion-based hydrogen sensor for fuel-cell electric vehicles

Pt/SnO 2 -Pd nanoelectrode applied for hydrogen sensor with zero-power consumption and low detection limit

Microbial fuel cell-based biosensor for toxic carbon monoxide monitoring

High-Performance Recognition, Cell-Imaging, and Efficient Removal of Carbon Monoxide toward a Palladium-Mediated Fluorescent Sensing Platform

The Detection of Hydrogen with A Nanotube Structured Sensor

Palladium Nanosheet-Based Dual Gas Sensors for Sensitive Room-Temperature Hydrogen and Carbon Monoxide Detection

Sub-second and ppm-level Optical Sensing of Hydrogen Using Templated Control of Nano-hydride Geometry and Composition

Metal Oxide Nanowire-Based Sensor Array for Hydrogen Detection

Large-Area Printed Oxide Film Sensors Enabling Ultrasensitive and Dual Electrical/Colorimetric Detection of Hydrogen at Room Temperature

Pt-Pd Bimetallic Nanocoral Modified Carbon Fiber Microelectrode As a Sensitive Hydrogen Peroxide Sensor for Cellular Detection

Molecular Sieve Based on a PMMA/ZIF-8 Bilayer for a CO-Tolerable H2 Sensor with Superior Sensing Performance

Nanoparticle-functionalized microsensors for room-temperature hydrogen detection