Abstract:The Moving Particle Semi-implicit-Controlled Volume (MPS-CV) method, based on the MPS method and Finite Volume Method (FVM), is a particle-grid coupling method. In this method, the particle interaction models in the MPS method are used to discretize and solve the momentum equation. For the eutectic reaction model, the FVM is used to solve the mass transfer equation if the particle locates at the boundary or the interface between different substances. In contrast, the particle interaction models are still used to discretize and solve the remaining particles' mass transfer equations. Therefore, it has advantages in describing fluid interfaces with large deformation and phase transition problems. Simultaneously, the MPS-CV method avoids the apparent error in calculating the mass transfer equation of boundary and interface between different substances due to the truncation of support domain in that area particles while using particle interaction models in the MPS method. In this study, the simulation of one-dimensional mass transfer and phase transition was used to verify the MPS-CV method, and the results were compared with those obtained by the MPS method. It showed that the MPS-CV method could get more accurate results in the calculation than the MPS method. Then the cladding oxidation mechanism at 1300 - 1800 K and the dissolution behavior between ZrO2 and molten zirconium at 2373 - 2573 K were analyzed using the MPS-CV method. The results indicated that the change of oxygen content obeyed parabolic laws. So did the oxide and alpha-Zr(O) layers' growth rates in cladding oxidation. And compared with the fixed parabolic relations used in commercial codes, the MPS-CV method can obtain the corresponding relationships according to different reaction conditions. The dissolution between ZrO2 and molten zirconium at high temperatures showed a parabolic pattern in the early stage. In the later stage of the reaction, the oxygen in the melt gradually reached saturation, and the solid ZrO2 did not continue to melt. The simulation results of the molten zirconium with the same volume but different contact areas with ZrO2 crucible showed that the larger the contact area was, the higher the growth rate of oxygen content in the melting the early stage of the reaction was. And it also showed that the larger the contact area was, the less dissolution volume of the ZrO2 crucible was.

Droplet impingement method to measure the surface tension of molten zirconium oxide

The Surface Tension of Ga2O3 Melt Measured by a Drop-Weight Method in an Optical Floating-Zone Furnace

Contactless surface tension measurement of molten oxides using oscillating drop method in an aerodynamic levitator

Numerical Investigation on the Dissolution Kinetics of ZrO 2 by Molten Zircaloy Using MPS Method

Unveiling the feature of deposition of oxygen and water molecules on the zirconium surface: A molecular dynamic study

Surface tension measurement of Ti–Zr and Ti–Hf alloys at high-temperature by the pendant drop method

Estimating Critical Surface Tension from Droplet Spreading Area

Investigation on Effect of Surface Properties on Droplet Impact Cooling of Cladding Surfaces

Influence of oxygen adsorption from atmosphere on surface tension of liquid silicon

Numerical Investigation of Oxidation and Dissolution Behavior in the Fuel Cladding Using MPS-CV Method

Wettability of molten titanium in Ti/zirconia system

Surface tension of binary Al–Si liquid alloys

Numerical investigation of micrometer sized droplet impingement on micro grooved surfaces

Measuring Dynamic Nonreactive Wetting Behavior Between Interstitial-Free Molten Steel and Alumina

Viscosity Measurement of Molten Alumina and Zirconia Using Aerodynamic Levitation, Laser Heating and Droplet Oscillation Techniques.

STUDY ON A MECHANICAL EQUILIBRIUM CONDITION AT A THREE-PHASE CONTACT LINE: WETTABILITY ON SOLID SURFACES

Effects of Surface Oxide Layer on the Impact Dynamic Behavior of Molten Aluminum Droplets

Experimental Study of a Micrometer-Sized Droplet Impinging on a Smooth Heated Surface

Numerical Analysis of the Dissolution of Uranium Dioxide by Molten Zircaloy Using Mps Method

Surface controlled mechanism of water boiling for nuclear reactor fuel assembly

Unraveling the characteristics of adsorption and diffusion of oxygen atoms on the surface of Zr and ZrO 2 crystals with point defects from molecular dynamic simulations