Abstract:The wetting phenomenon is crucial for the formation of stable liquid films on solid surfaces. The wettability of a liquid on a solid surface is characterized by the Young equation, which represents an equilibrium condition of a droplet at the three phase contact line. In general, the surface force in the vertical direction on a solid surface is ignored because of the resistance of the solid surface. However, considering the adhesion energy of the droplet rather than the force balance at the contact line, the vertical component of the surface force can be expected to be an important factor during wetting. Based on this concept, an analytical model is developed herein by considering the energy balance including adhesion forces acting not only in the horizontal but also in the vertical direction, in addition to the effect of gravity on the droplet. The validity of the developed model is then evaluated by experimental observation of the wetting phenomena of droplets on low- and high-surface-energy solids. Existing data are also used for evaluation of our model. The developed model describes the wetting phenomena of droplets with sizes ranging from nano- to millimeters under all experimental conditions and exhibits universality. In addition, on the basis of our model, the line tension is discussed. The results indicate that the line tension approach may be considered as a method to explain wetting phenomena by considering gravitational potential and other macroscopic parameters as a single parameter (i.e., line tension).

STUDY ON A MECHANICAL EQUILIBRIUM CONDITION AT A THREE-PHASE CONTACT LINE: WETTABILITY ON SOLID SURFACES

Discussion on a Mechanical Equilibrium Condition of a Sessile Drop on a Smooth Solid Surface

Macroscopic Wettability Based on an Interfacial Jump Condition.

J0230203 Analytical consideration of droplet wettability on solid surfaces

Wettability Model for Various-Sized Droplets on Solid Surfaces

Discussion on Young's Equation Based on Interfacial Jump Condition

Simple relations for wettability of a droplet on a low-surface-energy solid

CONTACT ANGLE VARIATION IN WATER DROPLETS ON LOW-SURFACE-ENERGY SOLIDS

Experimental and Theoretical Investigation of Contact-Angle Variation for Water–ethanol Mixture Droplets on a Low-Surface-energy Solid

Theoretical Model of Droplet Wettability on a Low-Surface-Energy Solid under the Influence of Gravity

EFFECT OF SOLID SURFACE PROPERTY ON GEOMETRIC VARIATIONS OF MICRO- TO MILLIMETER-SIZED WATER DROPLETS DURING VOLUME REDUCTION PROCESS

WETTING BEHAVIOR OF WATER MICRODROPLETS IN NATURAL EVAPORATION

Wettability Model for Water-Ethanol Binary Mixture Droplet on Roughened Low-Surface-energy Solids

Kinetics of Wetting of Liquid on a Solid Surface

Research Progress on Calculation of Solid Surface Tension Based on Young′s Equation

Universality of Droplet Impingement: Low-to-High Viscosities and Surface Tensions

Analytical Consideration of Liquid Droplet Impingement on Solid Surfaces

Research on Variation of Static Contact Angle in Incomplete Wetting System and Modeling Method

Experimental investigation on variations in geometric variables of a droplet on a low-surface-energy solid

Novel Characterization of Wetting Properties and the Calculation of Liquid-Solid Interface Tension(Ⅱ)

Analytical Consideration of Thermodynamic Jump Condition