Abstract:Large beam-anode layer ion source can produce high-density ions, and has been widely used in plasma cleaning and assisted deposition. However, when increasing the ion-beams, arcing always occurs inside the ion source and serious etching will take place on the cathode which results in sample pollution especially in long-time cleaning. This work proposes two designed structures, called magnetic shields surrounding the anode and sputtering shields on the top of the inner and outer cathodes, respectively. The influence of the designed structure on the electromagnetic field and the plasma properties of the ion source are studied by a self-established simulation techniques based on the particle-in-cell/Monte Carlo collision method and test particle Monte Carlo method. The results show that the magnetic shields surrounding the anode cut off the magnetic induction line between the cathode and anode, which eliminates the arcing condition in the ion source. The sputtering shields for the cathodes use alumina ceramics because of the extremely low sputtering yield and high insulation performance. Therefore, the sputtering shields can not only resist the ion sputtering, but also shield the electric field on the outer surface of the cathode. As a result, the plasma discharge region is compressed towards the anode and away from the cathode simultaneously, which provides a stronger electric field force directed to the output region for Ar+ ions, also resulting in a suppressed cathode etching behavior but an improved Ar+ ion output efficiency. The optimized calculation shows that the best distance from the sputtering shields to the cathode surface is 9 mm. The discharge experiments reveal that the modified ion source can eliminate the inside arcing and provide a clean and strong ion beam with a high efficiency. At the same discharge current, the output efficiency of the modified ion source is 36% higher than that of the original ion source. When used in the plasma cleaning, the glass substrate remains transparent and keeps the original element composition ratio. The detected Fe content, comes from the cathode sputtering, is only 0.03% after the plasma cleaning for 1 h, which is 2 orders of magnitude smaller than that cleaned by the original ion source. The Fe content of the modified ion source is about 0.6% of the original ion source, which is in good agreement with the result of simulation optimization.

Low energy solid intense ion beams extracted by electron beam evaporation ion source for material modifications

An evaporation source for ion beam assisted deposition in ultrahigh vacuum

A low-kiloelectronvolt focused ion beam strategy for processing low-thermal-conductance materials with nanoampere currents

Measurement and Simulation of Ultra-Low-Energy Ion-Solid Interaction Dynamics

A Broad Beam Cold Cathode Penning Ionization Gauge Ion Source For Ion-Beam-Assisted Deposition

Use of an energetic ion beam on the surface during physical vapor deposition

A very low energy ion beam extraction system design of the GTS ECR ion source at GANIL

Penning source for ion implantation

Low energy, high current density ion implantation of materials at elevated temperatures for tribological applications

A 16 Cm Broad-Beam Ion Source For Ion-Beam Etching Of Quartz Wafers

A New Method to Investigate the Intense Pulsed Ion Beam Ablation of Silica

Experimental Results of Ion Beam Extraction of High-Current Ion Source for EAST Neutral Beam Injector

Study and Elimination of the Cathode Etching on Large Beam-Anode Layer Ion Source

Uniformity optimization of ion beam sputtering coating equipment based on strong current ion source

Study on stray electrons ejecting from a long-pulse negative ion source for fusion

Low-energy N+ ion beam induced chemical vapor deposition using tetraethyl orthosilicate, hexamethyldisiloxane, or hexamethyldigermane

Surface Modification of Non-Semiconductors by Ion Beams in China

Production of Intense Atomic Nitrogen Beam Used for Doping and Synthesis of Nitride Film

A new machine for metal surface treatment by dynamic mixing using a high current ion source

Influence of high-voltage source stability on submicron beam diameter in focused ion beam optical system

Low-Energy Pulsed Ion Beam Technology with Ultra-High Material Removal Resolution and Widely Adjustable Removal Efficiency