Abstract:Glass ceramic (GC) is the most promising material for objective lenses for extreme ultraviolet lithography that must meet the subnanometer precision, which is characterized by low values of high spatial frequency surface roughness (HSFR). However, the HSFR of GC is typically degraded during ion beam figuring (IBF). Herein, a developed method for constructing molecular dynamics (MD) models of GC was presented, and the formation mechanisms of surface morphologies were investigated. The results indicated that the generation of the dot-like microstructure was the result of the difference in the erosion rate caused by the difference in the intrinsic properties between ceramic phases (CPs) and glass phases (GPs). Further, the difference in the microstructure of the IBF surface under different beam angles was mainly caused by the difference in the two types of sputtering. Quantum mechanical calculations showed that the presence of interstitial atoms would result in electron rearrangement and that the electron localization can lead to a reduction in CP stability. To obtain a homogeneous surface, the effects of beam parameters on the heterogeneous surface were systematically investigated based on the proposed MD model. Then, a novel ion beam modification (IBM) method was proposed and demonstrated by TEM and GIXRD. The range of ion beam smoothing parameters that could effectively converge the HSFR of the modified surface was determined through numerous experiments. Using the optimized beam parameters, an ultrathin homogeneous modified surface within 3 nm was obtained. The HSFR of GC smoothed by ion beam modification-assisted smoothing (IBMS) dropped from 0.348 to 0.090 nm, a 74% reduction. These research results offer a deeper understanding of the morphology formation mechanisms of the GC surfaces involved in ion beam processing and may point to a new approach for achieving ultrasmooth heterostructure surfaces down to the subnanometer scale.

Surface Modification of Non-Semiconductors by Ion Beams in China

Studies on surface modification of materials by intense pulsed ion beams

Recent research progress in the field of ion beam modification of materials in the Department of Technical Physics at Peking University

A Discussion on the Application and Production of Metal Ion Beams

Ion Beam Induced Surface Modification of Polymer and Application for Engineering

Development of Ion Sources for Materials Processing in China

Experimental Research on Surface Modification of Synthetic Diamond by Ion Beam Implantation

Surface Modification Technique of Structural Ceramics: Ion Implantation-Assisted Multi-Arc Ion Plating

Status and Development of Surface Alloying by Electron Beam

Magnetic field enhanced radio frequency ion source and its application for Si-incorporation diamond-like carbon film preparation

Polyatomic ions from a high current ion implanter driven by a liquid metal ion source

Modification for ceramic surfaces by ion implantation-assisted multi-arc ion plating technique

Long range interactions between micro spheres and alloy surfaces in water changed by ion implantation

Metal Ion Sources for Ion Beam Implantation

High Current Metal-Ion Implantation to Fabricate Metal Silicides

Subnanoscale Ion Beam Modification-Assisted Smoothing of Heterostructure Surfaces

Nanometer-scale modification and welding of silicon and metallic nanowires with a high-intensity electron beam.

Ag Ion Beam Irradiation Modification of Si and SiO2 Surfaces

Low energy solid intense ion beams extracted by electron beam evaporation ion source for material modifications

Direct ion-beam deposition of Ag nanoparticles using a solid-state silver ion source