Abstract:Nanostructured Ni–Fe alloy coatings were developed galvanostatically using a new low-concentration bath. The composition and operating parameters of the bath were optimised by taking the benefit of the conventional Hull cell method. Ni–Fe alloy coatings were developed at different current densities (2.0 to 5.0 A dm −2 ), keeping pH = 2.5. The corrosion behaviour of electrodeposited alloy coatings was evaluated in 3.5% NaCl solution, using Electrochemical Impedance Spectroscopy (EIS) and potentiodynamic polarisation methods. Ni–Fe alloy coating, deposited at 2.0 A dm −2 exhibited a lesser corrosion rate (14.71 × 10 −2 mm y −1 ) than those at higher current densities. The lowest corrosion rate was attributed to its least crystallite size (10.4 nm), evidenced by an X-Ray Diffraction (XRD) study. The corrosion performance of Ni–Fe alloy coatings was discussed in the light of their surface morphology and composition, evidenced by SEM and Energy-Dispersive X-ray spectroscopy (EDS) analysis, respectively. On a développé de manière galvanostatique des revêtements en alliage Ni–Fe en utilisant un nouveau bain à faible concentration. On a optimisé la composition et les paramètres de fonctionnement du bain en profitant de la méthode conventionnelle de la cellule de Hull. On a développé des revêtements en alliage Ni–Fe à différentes densités de courant (2.0 à 5.0 A dm −2 ), en maintenant le pH = 2.5. On a évalué dans une solution de NaCl à 3.5% le comportement à la corrosion des revêtements de l'alliage électrodéposés, en utilisant les méthodes de spectroscopie d'impédance électrochimique (EIS) et de polarisation potentiodynamique. Il s'est avéré que le revêtement en alliage Ni–Fe déposé à 2.0 A dm −2 présentait le taux de corrosion le plus faible (14.71 × 10 −2 mm an −1 ), comparé à ceux présentant des densités de courant plus élevées. Le taux de corrosion le plus faible était attribué à la plus petite taille de cristallite (10.4 nm), mise en évidence par une étude de diffraction des rayons X (DRX). On a discuté de la performance à la corrosion des revêtements en alliage Ni–Fe à la lumière de leur morphologie et de leur composition de surface, mises en évidence respectivement par analyse de microscopie électronique à balayage (MEB) et de spectroscopie de rayons X à dispersion d'énergie (EDS).

Electroplating of Nanocrystalline Ni–Co Alloys Using Cysteine and Their Electrochemical Behaviour in NaOH Solution

Electroplating and Physicochemical Properties of Zinc–Nickel Alloy Coatings from Ammonium Oxalate Electrolytes

Electroplating and characterization of Zn–Ni, Zn–Co and Zn–Ni–Co alloys

Electrodeposition of Ni–Co alloys from a deep eutectic solvent

Electrodeposition and corrosion performance of Ni-Co alloys with different cobalt contents

The Performance of Zn-Ni Alloy Coating Electrodeposited from Stabilized Bath

Composite Electroless Nickel-nano Al2O3 Coatings on Steel Substrate

Influence Of Alpha-Al2o3 Nanoparticles On The Anomalous Electrodeposition Of Co-Ni Alloys

Electrodeposition of Nanostructured Co–Cu Thin Alloy Films on to Steel Substrate from an Environmentally Friendly Novel Lactate Bath under Different Operating Conditions

Preparation, characterisation and electrochemical study of crack-free nanocrystalline electrodeposited Co-W alloy coating of high hardness

Effect of cobalt content on electrodeposition and properties of Co–Ni alloy thin films

Electrodeposition of nanocrystalline Ni-Mo alloys in pyrophosphate baths

Electrodeposition of Ni, Co and Ni–Co alloy powders

Effect of Α-Al2o3 Particles on the Electrochemical Codeposition of Co–Ni Alloys from Sulfamate Electrolytes

Nickel Salt Dependency as Catalyst in the Plating Bath on the Film Properties of Cu/Cu-Ni

Evaluation of corrosion resistance of electrodeposited nanocrystalline Ni–Fe alloy coatings

Structure and corrosion property of pulse electrodeposited nanocrystalline nickel-tungsten-copper alloy coating

Electrochemical development and characterisation of nanostructured Ni–Fe alloy coatings for corrosion protection

Electrochemical Synthesis and Characterization of Ni–P Alloy Coatings from Eutectic–Based Ionic Liquid

Electrodeposition and characterization of Ni-Mo alloy as an electrocatalyst for alkaline water electrolysis

A Method for Electroless Nickel Plating on Aluminum Alloy Surface