Abstract:Nanostructured Ni–Fe alloy coatings were developed galvanostatically using a new low-concentration bath. The composition and operating parameters of the bath were optimised by taking the benefit of the conventional Hull cell method. Ni–Fe alloy coatings were developed at different current densities (2.0 to 5.0 A dm −2 ), keeping pH = 2.5. The corrosion behaviour of electrodeposited alloy coatings was evaluated in 3.5% NaCl solution, using Electrochemical Impedance Spectroscopy (EIS) and potentiodynamic polarisation methods. Ni–Fe alloy coating, deposited at 2.0 A dm −2 exhibited a lesser corrosion rate (14.71 × 10 −2 mm y −1 ) than those at higher current densities. The lowest corrosion rate was attributed to its least crystallite size (10.4 nm), evidenced by an X-Ray Diffraction (XRD) study. The corrosion performance of Ni–Fe alloy coatings was discussed in the light of their surface morphology and composition, evidenced by SEM and Energy-Dispersive X-ray spectroscopy (EDS) analysis, respectively. On a développé de manière galvanostatique des revêtements en alliage Ni–Fe en utilisant un nouveau bain à faible concentration. On a optimisé la composition et les paramètres de fonctionnement du bain en profitant de la méthode conventionnelle de la cellule de Hull. On a développé des revêtements en alliage Ni–Fe à différentes densités de courant (2.0 à 5.0 A dm −2 ), en maintenant le pH = 2.5. On a évalué dans une solution de NaCl à 3.5% le comportement à la corrosion des revêtements de l'alliage électrodéposés, en utilisant les méthodes de spectroscopie d'impédance électrochimique (EIS) et de polarisation potentiodynamique. Il s'est avéré que le revêtement en alliage Ni–Fe déposé à 2.0 A dm −2 présentait le taux de corrosion le plus faible (14.71 × 10 −2 mm an −1 ), comparé à ceux présentant des densités de courant plus élevées. Le taux de corrosion le plus faible était attribué à la plus petite taille de cristallite (10.4 nm), mise en évidence par une étude de diffraction des rayons X (DRX). On a discuté de la performance à la corrosion des revêtements en alliage Ni–Fe à la lumière de leur morphologie et de leur composition de surface, mises en évidence respectivement par analyse de microscopie électronique à balayage (MEB) et de spectroscopie de rayons X à dispersion d'énergie (EDS).

Evaluation of corrosion resistance of electrodeposited nanocrystalline Ni–Fe alloy coatings

Electrochemical development and characterisation of nanostructured Ni–Fe alloy coatings for corrosion protection

Electroplating and Physicochemical Properties of Zinc–Nickel Alloy Coatings from Ammonium Oxalate Electrolytes

Effect of electroless deposition on the corrosion resistance property for NdFeB permanent magnets with surface coating of Ni-P alloy

Electrodeposition of nanocrystalline Ni-Mo alloys in pyrophosphate baths

Electrochemical Deposition and Corrosion Resistance Characterization of FeCoNiCr High-Entropy Alloy Coatings

The Performance of Zn-Ni Alloy Coating Electrodeposited from Stabilized Bath

Evaluation of the corrosion resistance of AlCoCrFeMnNi high entropy alloy hard coating applied by electro spark deposition

Microstructure and Properties of Electrodeposited Nanocrystalline Ni-Co-Fe Coatings

Electrochemical behavior and electro-crystallization mechanism of Cu-Ni/Nano-Al 2 O 3 coating with a deposition current density dependence

Influence of Electrodeposition Conditions on the Microstructure and Corrosion Resistance of Zn–Ni Alloy Coatings from a Deep Eutectic Solvent

Electrodeposition and Corrosion Analysis of Ni-Mo Alloy Coatings

Electroplating and characterization of Zn–Ni, Zn–Co and Zn–Ni–Co alloys

Study of the Effect of Current Density on the Metallurgical Properties of AlFeCrNiTi High Entropy Alloy Coating Produced by Pulse Plating

Deposition of nickel films on polycrystalline copper alloy with various current densities from watts solution

Effects of substrate materials and electrodeposition parameters on hydrogen evolution reaction of Ni–Cu–Fe coatings

Wear and Corrosion Properties of Crystalline Ni-W Alloy Coatings Prepared by Electrodeposition

Microstructure and Corrosion Properties of Electrodeposited CoCrFeMnNi High Entropy Alloy Coatings

Evaluation of Ni–B alloy electroplated with different anionic groups

Pulsed electroplating of ZrO2-reinforced Ni-Cr alloy coatings from the duplex complexing agents-containing bath for engineering applications: Importance of operating conditions

Electrochemical behavior and electrodeposition of Fe-Co-Ni thin films in choline chloride/urea deep eutectic solvent