Abstract:The electrodeposition of chromium oxide-hydroxide films from Cr(III) electrolytes has recently become a significant focus in electrochemistry, holding promise for applications in packaging industry and corrosion protection, as an environmentally friendly alternative for Cr(VI). However, the complex behavior of Cr(III) complexes has resulted in a scarcity of precise electrochemical investigations in this field. In this study, we employ in-situ techniques such as Electrochemical Quartz Crystal Microbalance (EQCM) and Electrochemical Scanning Tunneling Microscopy (EC-STM) in conjunction with cyclic voltammetry (CV) to elucidate the mechanisms governing the formation of chromium oxide-hydroxide films through electrodeposition in an acidic environment. CV studies explore the electrochemical reactions involved in the electrodeposition process, showing that hydrogen evolution is the dominant reaction. The resulting interfacial pH changes trigger the hydrolysis of hydrated chromium(III) cations, leading to oligomerization and the precipitation of a chromium hydroxide compound. In-situ monitoring of mass changes during film formation process using EQCM reveals that there is a critical pH range for oxide-hydroxide film formation, outside of which no deposition/precipitation occurs. EC-STM results confirms the formation of a film on the cathode surface, and its sensitivity to the interfacial pH. At a sufficiently high local pH, under our experimental conditions happening at potentials more negative than -0.95 V, the film alters into a state that becomes stable and insoluble.

In situ Monitoring of pH at the Electrode|Electrolyte Interface During the Anodic Dissolution of Iron in Acidic Solutions

Use of Oxidation-Reduction Potential to Monitor Iron Release from Corroded Iron Pipes in Drinking Water Distribution System

Impedance investigation of the anodic iron dissolution in perchloric acid solution

Quasi-simultaneous electrochemical/chemical imaging of local Fe2+ and pH distributions on 316 L stainless steel surface

The spatial structures of iron oxide formed on an ordered Pt(111) electrode in pH 3 sulfate and chloride media

EIS analysis on the anodic dissolution kinetics of pure iron in a highly alkaline solution

Anodic behavior of Fe in acidic AlCl3-EMIC ionic liquid

A Fabrication of Iridium Oxide Film Ph Micro-Sensor on Pt Ultramicroelectrode and Its Application on In-Situ Ph Distribution of 316L Stainless Steel Corrosion at Open Circuit Potential

Pii: s0375-9601(00)00794-5

Corrosion Potential Oscillation of Iron Electrodes in Nitric Acid

Separation and Kinetic Study of Iron Corrosion in Acidic Solution Via a Modified Tip Generation/substrate Collection Mode by SECM

Quantitative Analysis of the Polarization Behavior of Iron in an Aerated Acidic Solution Using SECM

Stability and dissolution of single-crystalline iron oxide thin films in electrochemical environments

An ac impedance study of the anodic dissolution of iron in sulfuric acid solutions containing hydrogen sulfide

Effect of citric acid as a chelating agent on anodic behavior of pure iron with potentiostatic polarization and cyclic voltammetry methods

Mechanism of Cr(III)-based Oxide-Hydroxide Film Electrodeposition in an Acidic Solution

Novel Dual Pt-Pt/IrOx Ultramicroelectrode for Ph Imaging Using SECM in Both Potentiometric and Amperometric Modes

Electrode Reaction Induced Ph Change at the Pt Electrode/electrolyte Interface and Its Impact on Electrode Processes

An In-Situ Study of Copper Electropolishing in Phosphoric Acid Solution

Electrochemical behaviors of co-deposited Pb/Pb–MnO 2 composite anode in sulfuric acid solution – Tafel and EIS investigations

A study of the reactivation process of iron in acid solution