Abstract:Research studies on zinc metal-based batteries have attracted considerable attention as a candidate for post-lithium-ion batteries. Zinc is one of the few metal anodes that is compatible with aqueous and non-aqueous electrolytes, providing a large theoretical capacity of 820 mAh g-1. However, in aqueous electrolytes, the zinc metal anode suffers from hydrogen evolution reaction (HER), by which zinc is irreversibly consumed or corroded continually. Exact estimation of the corrosion rate has been a challenge in the development of Zn-based batteries. Measurement of the corrosion rate by conventional Tafel analysis meets serious problems because the cathodic current reflects deposition of Zn metal as well as HER, inhibiting exact measurement of the corrosion rate. Herein, we developed a chronocoulometric "deposition-rest-dissolution" method to quantify the corrosion rate without such interference from the deposition of Zn. The method was successfully applied to the quantification of the rate of chemical corrosion of Zn in aqueous electrolytes with various pH and concentration values. The "deposition-rest-dissolution" method and electrochemical impedance spectroscopy confirmed that saturated ZnSO4 (ca. 3.2 M) + 0.075 M Li2SO4 delivers the lowest corrosion rate compared to the other electrolytes, probably because the activity of water in such a concentrated electrolyte is low enough to suppress the kinetics of HER. Moreover, this method can be generally applied to determine the rate of chemical corrosion on various metal electrodes.

Separation and Kinetic Study of Iron Corrosion in Acidic Solution Via a Modified Tip Generation/substrate Collection Mode by SECM

Quantitative Analysis of the Polarization Behavior of Iron in an Aerated Acidic Solution Using SECM

Corrosion Electrochemical Kinetic Study of Copper in Acidic Solution Using Scanning Electrochemical Microscopy

The Study of the H2O2 During Oxygen Reduction Process on Typically Corroding Metal Surface Using Tip Generation-Substrate Collection Mode of SECM

Corrosion Behavior of Pure Mg Based on Generation/Collection and Feedback Modes of Scanning Electrochemical Microscopy

Quantitative study on the metal dissolution reaction with multivalent cations by a modified SECM mode: Pure Ti as a case

Quasi-simultaneous electrochemical/chemical imaging of local Fe2+ and pH distributions on 316 L stainless steel surface

Anodic behavior of Fe in acidic AlCl3-EMIC ionic liquid

Determining kinetics of electrochemical carbon dioxide reduction to carbon monoxide with scanning electrochemical microscopy

An ac impedance study of the anodic dissolution of iron in sulfuric acid solutions containing hydrogen sulfide

Novel Dual Pt-Pt/IrOx Ultramicroelectrode for Ph Imaging Using SECM in Both Potentiometric and Amperometric Modes

In situ Monitoring of pH at the Electrode|Electrolyte Interface During the Anodic Dissolution of Iron in Acidic Solutions

Impedance investigation of the anodic iron dissolution in perchloric acid solution

The Influence of Hydrogen Sulfide on Corrosion of Iron under Different Conditions

Corrosion Micro- and Macro-Electrochemical Behavior of Rusted Carbon Steel and Weathering Steel

In Situ SECM Mapping of Pitting Corrosion in Stainless Steel Using Submicron Pt Ultramicroelectrode and Quantitative Spatial Resolution Analysis

EIS analysis on the anodic dissolution kinetics of pure iron in a highly alkaline solution

A Chronocoulometric Method to Measure the Corrosion Rate on Zinc Metal Electrodes

Hot-Tip Scanning Electrochemical Microscopy: Theory and Experiments Under Positive and Negative Feedback Conditions

Detection of Hydrogen Peroxide Produced at a Liquid/liquid Interface Using Scanning Electrochemical Microscopy

Corrosion Investigation by Scanning Electrochemical Microscopy of AISI 446 and Ti-Coated AISI 446 Ferritic Stainless Steel as Potential Material for Bipolar Plate in PEMWE