Abstract:H 1.6 Mn 1.6 O 4 lithium-ion sieve with spinel structure was successfully prepared by hydrothermal, high-temperature calcination and ion exchange reaction. XRD, SEM, TEM, N 2 ad/desorption and FTIR methods were employed to characterize the microstructure and morphology of the synthesized materials in detail. The experimental results show that H 1.6 Mn 1.6 O 4 has the characteristics of mesoporous structure and nanotube morphology with length of ∼ 10 μm and diameter of 500–700 nm, and the spiny structure was grown on the surface of the nanotube uniformly. The effect of Al 3+ doping on the structure and morphology of H 1.6 Mn 1.6 O 4 was studied. The results show that Al 3+ doping does not change the microstructure and morphology of H 1.6 Mn 1.6 O 4 , but the specific surface area and pore volume are increased to a certain extent. H 1.6 Mn 1.6 O 4 and H 1.6 Mn 1.6−x Al x O 4 were used as lithium-ion adsorbents to study the adsorption properties of Li + in solution. The adsorption experiment results show that the adsorption capacity of H 1.6 Mn 1.6 O 4 increased with increasing solution pH value, indicating that the strong alkaline solution with higher pH value is more favorable for Li + adsorption. The adsorption isotherm results show that Li + adsorption process was fitted well by Langmuir model, indicating that Li + maybe adsorbed on the surface of manganese oxides lithium-ion sieves via a monolayer adsorption. The theoretical maximum adsorption capacity of H 1.6 Mn 1.6 O 4 and H 1.6 Mn 1.6−x Al x O 4 can reach 39.54 mg/g and 40.54 mg/g, respectively. The results of adsorption kinetics show that the adsorption rate of both H 1.6 Mn 1.6 O 4 and H 1.6 Mn 1.6−x Al x O 4 is fast, and the adsorption capacity of H 1.6 Mn 1.6−x Al x O 4 (24.65 mg/g) is slightly better than H 1.6 Mn 1.6 O 4 (24.33 mg/g). Li + adsorption process can be well described by the pseudo-second-order model, suggesting adsorption behavior is mainly controlled by chemical sorption. Additionally, the free energy change (Δ G Θ ) was determined by Van't Hoff equation is negative, which confirms the adsorption process is spontaneous and feasible. The positive value of Δ S Θ of adsorption reaction reflects there is a certain of affinity between manganese oxides lithium-ion sieves and Li + in solution.

Introduction of manganese based lithium-ion Sieve-A review

Practical synthesis of manganese oxide MnO2·0.5H2O for an advanced and applicable lithium ion-sieve

Al and Cr ions co-doped spinel manganese lithium ion-sieve with enhanced Li + adsorption performance and structural stability

Preparation of layered lithium ion-sieve by solid-phase method and their lithium extraction performance

MnO2 ion-sieve for lithium adsorption from aqueous resources

Synthesis and adsorption properties of metal oxide-coated lithium ion-sieve from salt lake brine

Manganese-Titanium Mixed Ion Sieves for the Selective Adsorption of Lithium Ions from an Artificial Salt Lake Brine

Lithium Selective Adsorption on 1-D MnO2 Nanostructure Ion-Sieve

Preparation of HMn2O4 lithium-ion sieves with low manganese dissolution loss for improved cycling stability

Synthesis and optimisation mechanism of functionalised adsorption materials for lithium-ion extraction: a review

Enhanced lithium-ion adsorption by recyclable lithium manganese oxide-sepiolite composite microsphere from aqueous media: Fabrication, structure, and adsorption characteristics

Nanostructure Ion-Sieves for Lithium Adsorption

Synthesis, Characterization And Property Of Nanooxide Lithium Ion-Sieve

Highly efficient and selective extraction of Li+ from high sodium lithium containing wastewater using manganese series adsorbent

Preparation, modification and adsorption properties of spinel-type H1.6Mn1.6O4 lithium-ion sieves with spiny nanotube morphology

Application and Mechanism of Lithium-ion Sieves in the Recovery of Lithium-Containing Wastewater: a Review

Manganese-based spinel adsorbents for lithium recovery from aqueous solutions by electrochemical technique

Lithium extraction/insertion process on cubic Li-Mn-O precursors with different Li/Mn ratio and morphology

Recent Advance in Mn-based Li-rich Cathode Materials: Oxygen Release Mechanism and Its Solution Strategies Based on Electronic Structure Perspective, Spanning from Commercial Liquid Batteries to All-Solid-state Batteries

Annealed SiO2 Protective Layer on LiMn2O4 for Enhanced Li-Ion Extraction from Brine.

Adsorption Materials for Lithium Ion from Brine Resources and Their Performances