Manganese-Titanium Mixed Ion Sieves for the Selective Adsorption of Lithium Ions from an Artificial Salt Lake Brine

Yaxuan Ding,Nguyen Thi Hong Nhung,Jiahao An,Hao Chen,Lianying Liao,Chunlin He,Xinpeng Wang,Toyohisa Fujita

DOI: https://doi.org/10.3390/ma16114190

IF: 3.4

2023-06-05

Materials

Abstract:Lithium recovery is imperative to accommodate the increase in lithium demand. Salt lake brine contains a large amount of lithium and is one of the most important sources of lithium metal. In this study, Li2CO3, MnO2, and TiO2 particles were mixed, and the precursor of a manganese–titanium mixed ion sieve (M-T-LIS) was prepared by a high-temperature solid-phase method. M-T-LISs were obtained by DL-malic acid pickling. The adsorption experiment results noted single-layer chemical adsorption and maximum lithium adsorption of 32.32 mg/g. From the Brunauer–Emmett–Teller and scanning electron microscopy results, the M-T-LIS provided adsorption sites after DL-malic acid pickling. In addition, X-ray photoelectron spectroscopy and Fourier transform infrared results showed the ion exchange mechanism of the M-T-LIS adsorption. From the results of the Li+ desorption experiment and recoverability experiment, DL-malic acid was used to desorb Li+ from the M-T-LIS with a desorption rate of more than 90%. During the fifth cycle, the Li+ adsorption capacity of the M-T-LIS was more than 20 mg/g (25.90 mg/g), and the recovery efficiency was higher than 80% (81.42%). According to the selectivity experiment, the M-T-LIS had good selectivity for Li+ (adsorption capacity of 25.85 mg/g in the artificial salt lake brine), which indicates its good application potential.

materials science, multidisciplinary,chemistry, physical,physics, applied, condensed matter,metallurgy & metallurgical engineering

What problem does this paper attempt to address?

This paper aims to address the issue of efficiently extracting lithium ions from salt lake brine. Specifically, the study investigates the selective adsorption performance of manganese-titanium mixed ion sieve (M-T-LIS) for lithium ions in artificial salt lake brine. The M-T-LIS precursor was prepared by a high-temperature solid-phase method and treated with DL-tartaric acid for acid washing. Experimental results show that M-T-LIS exhibits monolayer chemical adsorption characteristics, with a maximum lithium adsorption capacity of 32.32 mg/g. Additionally, after acid washing with DL-tartaric acid, M-T-LIS provided more adsorption sites. X-ray photoelectron spectroscopy (XPS) and Fourier transform infrared spectroscopy (FT-IR) results revealed the ion exchange mechanism during the M-T-LIS adsorption process. Desorption and recovery experiments of lithium ions indicated that DL-tartaric acid could desorb lithium ions from M-T-LIS with a desorption rate of over 90%. After 5 cycles, the lithium ion adsorption capacity of M-T-LIS remained above 20 mg/g (25.90 mg/g), with a recovery efficiency higher than 80% (81.42%). Selectivity experiments demonstrated that M-T-LIS has good selectivity for lithium ions in artificial salt lake brine (adsorption capacity of 25.85 mg/g), showing its promising application potential. Therefore, the main objective of this study is to develop a simple and efficient lithium ion adsorption material for extracting lithium from salt lake brine.

Manganese-Titanium Mixed Ion Sieves for the Selective Adsorption of Lithium Ions from an Artificial Salt Lake Brine

Lithium ion sieve synthesized via an improved solid state method and adsorption performance for West Taijinar Salt Lake brine

Highly efficient and selective extraction of Li+ from high sodium lithium containing wastewater using manganese series adsorbent

Practical synthesis of manganese oxide MnO2·0.5H2O for an advanced and applicable lithium ion-sieve

Al and Cr ions co-doped spinel manganese lithium ion-sieve with enhanced Li + adsorption performance and structural stability

Study on adsorption extraction process of lithium ion from West Taijinar brine by shaped titanium-based lithium ion sieves

Synthesis and adsorption properties of metal oxide-coated lithium ion-sieve from salt lake brine

Preparation of layered lithium ion-sieve by solid-phase method and their lithium extraction performance

Synthesis of High Specific Surface Lithium-Ion Sieve Templated by Bacterial Cellulose for Selective Adsorption of Li+

An ion sieve-tailored biomimetic porous nanofibrous as an efficient adsorbent for lithium extraction from brine

MnO2 ion-sieve for lithium adsorption from aqueous resources

Extraction of lithium from salt lake brines by granulated adsorbents

Highly Efficient Lithium Extraction from Brine with a High Sodium Content by Adsorption-Coupled Electrochemical Technology

Adsorbents for lithium extraction from salt lake brine with high magnesium/lithium ratio: From structure-performance relationship to industrial applications

Synthesis of High Specific Surface Lithium ion Sieve Templated by Bacterial Cellulose for Selective Adsorption of Li+

Recovery of Lithium Ions From Salt Lakes Using Nanofibers Containing Zeolite Carriers

Electrochemical lithium recovery from brine with high Mg2+/Li+ ratio using mesoporous λ-MnO2/LiMn2O4 modified 3D graphite felt electrodes

Highly selective separation of lithium with hierarchical porous lithium-ion sieve microsphere derived from MXene

Development of a Manganese Dioxide-Decorated Activated Carbon Nano-sorbent via Co-precipitation method for efficient lithium ion adsorption from aqueous solutions

Li‐Ions Pre‐intercalation Strategy of Manganese Oxides for Capacitive Deionization‐Based Selective Lithium Extraction From Low‐grade Brine

Bifunctional Modification Enhances Lithium Extraction from Brine Using a Titanium-Based Ion Sieve Membrane Electrode