Abstract:In order to increase entry gas temperature and improve the efficiency of gas turbine, steam is used as a coolant instead of air. Much research has been carried out on the closed circuit steam cooling of vanes substituted with film-cooling using compressor air in recent years. Furthermore, by studying the steam flow and heat transfer characteristics in rib ducts, this investigation focuses on establishing the basis of steam cooling technology application in complex flow field of internally-cooled turbine vane.In this paper, a report and assessment of RSM method based on SSG turbulence model is performed with commercial computational fluid dynamics software ANSYS CFX. The numerical results of heat transfer coefficient and friction factors in square channels with 90 degree rib turbulators for Reynolds numbers of 10 000, 30 000 and 60 000 are compared with the experimental data from Han's. It is found that the obtained heat transfer coefficient distributions and friction factors match well with SSG turbulence model. In addition, the heat transfer distribution and. pressure drop of steam-cooled ducts are predicted under the same work conditions by using dry real gas model. The Reynolds number could be correlated with the Nusselt number. The impact of steam physical properties on heat transfer performance are researched detailedly by respectively changing the steam superheat and entry pressure.The results indicate that the RSM method with a suitable turbulence model is valuable for the air-cooled and steam-cooled duct with the acceptable engineering accuracy (less than 20%). Comparing the cooling efficiency between steam and air under the same operation condition, the advantage of using cooling steam is evident than using cooling air. Furthermore, the efficiency of the whole gas turbine system will be greatly improved through using the closed loop steam cooling system. Changing the steam superheat and entry pressure, it has little effect on the steam flow and heat transfer characteristics. Increasing the steam overheat would raise the friction factor. Contrarily, enhancing the entry pressure would decrease the friction factor.

A numerical study of heat transfer effects and aerodynamic noise reduction in superheated steam flow passing a temperature and pressure regulation valve

A Parametric Study on Cavitation Flow Through Steam Trap Valves under High Pressure Difference

Numerical analysis of aerodynamic noise in a high parameter pressure reducing valve

Aerodynamics Analysis of Superheated Steam Flow Through Multi-Stage Perforated Plates

Numerical Study on Flow Characteristics in High Multi-Stage Pressure Reducing Valve

Cavitation and Acoustic Analysis of Sleeve Steam Trap under Multiple Working Conditions

Numerical Simulation of Flow-Induced Noise in High Pressure Reducing Valve

Throttling Components Effect on Aerodynamic Performance of Superheated Steam Flow in Multi-Stage High Pressure Reducing Valve

Numerical and experimental investigation of cavitation characteristics of the electronic expansion valves

The Effects of the Orifice Plate Structure on the Aerodynamic Noise in the High Parameter Pressure Reducing Valve

A Combined Delayed Detached Eddy Simulation and Linearized Navier-Stokes Equation Study on the Generation and Reduction of Aerodynamic Noises Inside Steam Turbine Control Valve with Acoustic Liner

Flow-induced vibration and noise in control valve

Numerical Simulation and Structure Improvement of Double Throttling in A High Parameter Pressure Reducing Valve

Effects of Throttling Orifice Plate on Flow and Aerodynamic Noise Characteristics Inside Valve Downstream

Numerical Investigation Of Heat Transfer And Flow Characteristics In A Steam-Cooled Square Ribbed Duct

Numerical study on acoustic characteristics of flow boiling in a helical tube

Numerical Investigation into Acoustics Characteristics towards Pressure Reducing Valve with High Ratio of Reduced Pressure

Numerical Investigation of Heat Transfer to Supercritical Pressure Water in Vertical Tube with Non-Uniform Heating Form

Computational fluid dynamics of steam flow in a turbine control valve with a bell-shaped spindle

Investigation And Modeling Of The In-Tube Heat Transfer Of Fluids At Supercritical Pressure During Heating

Investigation of the Flow-Induced Noise and Optimization Design of a Short Tube Throttle Valve