Abstract:Abstract Two full-scale building specimens were tested on the shake-table at the EUCENTRE Foundation laboratories in Pavia (Italy), to assess the effectiveness of an innovative timber retrofit solution, within a comprehensive research campaign on the seismic vulnerability of existing Dutch unreinforced masonry structures. The buildings represented the end-unit of a two-storey terraced house typical of the North-Eastern Netherlands, a region affected by induced seismicity over the last few decades. This building typology is particularly vulnerable to earthquake excitation due to lack of seismic details and irregular distribution of large openings in masonry walls. Both specimens were built with the same geometry. Their structural system consisted of cavity walls, with interior load-bearing calcium-silicate leaf and exterior clay veneer, and included a first-floor reinforced concrete slab, a second-floor timber framing, and a roof timber structure supported by masonry gables. A timber retrofit was designed and installed inside the second specimen, providing an innovative sustainable, light-weight, reversible, and cost-effective technique, which could be extensively applied to actual buildings. Timber frames were connected to the interior surface of the masonry walls and completed by oriented strands boards nailed to them. The second-floor timber diaphragm was stiffened and strengthened by a layer of oriented-strand boards, nailed to the existing joists and to additional blocking elements through the existing planks. These interventions resulted also in improved wall-to-diaphragm connections with the inner leaf at both floors, while steel ties were added between the cavity-wall leaves. The application of the retrofit system favored a global response of the building with increased lateral capacities of the masonry walls. This paper describes in detail the bare and retrofitted specimens, compares the experimental results obtained through similar incremental dynamic shake-table test protocols up to near-collapse conditions, and identifies damage states and damage limits associated with displacements and deformations.

Out-of-plane Response of an Innovative Masonry Infill with Sliding Joints from Shaking Table Tests

Dynamic Progressive Collapse Response of Multi-Storey Frame Structures with Masonry Infills

Cyclic Response of Infilled RC Frames with Window and Door Openings: Experimental Results and Damage Interpretation

Experimental Study of RC Frames with Window and Door Openings Under Cyclic Loading

In-Plane Lateral Response of a Full-Scale Masonry Subassemblage with and without an Inorganic Matrix-Grid Strengthening System

Seismic assessment of the in‐plane/out‐of‐plane interaction of masonry infills in a two‐storey RC building subjected to bi‐directional shaking table tests

Nonlinear Behavior of a Masonry Subassemblage Before and After Strengthening with Inorganic Matrix-Grid Composites

Seismic Protection of RC Buildings by Polymeric Infill Wall-Frame Interface

An Innovative, Lightweight, and Sustainable Solution for the Integrated Seismic Energy Retrofit of Existing Masonry Structures

Tie system to upgrade out‐of‐plane performance of infill masonry walls

Dynamic Tests of a Large-Scale Three-Story RC Structure with Masonry Infill Walls

Full‐scale shake‐table tests on two unreinforced masonry cavity‐wall buildings: effect of an innovative timber retrofit

Strain Monitoring and Crack Detection in Masonry Walls under In-Plane Shear Loading Using Smart Bricks: First Results from Experimental Tests and Numerical Simulations

Numerically based proposals for the stiffness and strength of masonry infills with openings in reinforced concrete frames

Influence of Masonry Infill Walls on the Seismic Assessment of Non-Seismically Designed RC Framed Structures

Study on in-plane/out-of-plane seismic performance of masonry-infilled RC frame with openings and a new type of flexible connection

Field measurements for calibration of simplified models of the stiffening effect of infill masonry walls in high-rise RC framed and shear-wall buildings

Combined Strengthening Techniques to Improve the Out-of-Plane Performance of Masonry Walls

In-Plane Strengthening Effect of Prefabricated Concrete Walls on Masonry Structures: Shaking Table Test

Parametric study on the in-plane performance of a steel frame retrofit solution for URM buildings using DEM

Seismic behaviour of masonry infilled hinged steel frames with openings: experimental and numerical studies