Development of a conceptual direct solvent extraction (DSX) route to produce purified concentrated cobalt and nickel solutions representing sulfuric acid leach liquor of laterite
Alexandre Silva Guimarães,Georgio Patrício de Souza Resende,Iranildes Daniel dos Santos,Marcelo Borges Mansur
DOI: https://doi.org/10.1016/j.hydromet.2024.106321
IF: 4.217
2024-04-25
Hydrometallurgy
Abstract:Direct solvent extraction (DSX) was applied to produce purified concentrated Ni and Co solutions from a synthetic sulfuric liquor containing Ca, Cu, Mg, Mn, and Zn as impurities, which simulates the solution obtained by the sulfation-roasting-leaching process after precipitation of Fe, Al, and Cr. The commercial extractants Versatic 10, Cyanex 272, D2EHPA, TBP were used in 3 solvent extraction circuits. In the first circuit, operated at 40 °C, Versatic 10 (0.5 M) fully extracted Cu, Zn, Ni, and Co in 3 stages at O/A = 2:1, and pH 6.5, leaving remaining Mn (54% was extracted) and most of the Ca and Mg in the raffinate. The co-extracted Ca and Mg were fully scrubbed off the loaded Versatic 10 in 2 stages at O/A = 5:1, and pH 6.5. The other metals were stripped out of the Versatic 10 extract using a synthetic Ni spent electrolyte (60 g/L Ni, 2 M H 2 SO 4 ) in 2 stages at O/A = 9:1. This loaded strip liquor was subjected to a second circuit with Cyanex 272 (0.64 M) operated at 50 °C. Three stages were required to fully extract Co, Cu, Mn, and Zn (O/A = 2:1, pH 4), whereas the raffinate containing 82 g/L Ni was deemed suitable for electrowinning. The co-extracted Ni(II) was fully scrubbed off the loaded Cyanex 272 in only 1 stage at O/A = 5:1, and pH 4. All Co, Cu, Mn, and Zn were stripped out from the scrubbed loaded Cyanex 272 in 2 stages at O/A = 10:1 using a synthetic Co spent electrolyte (45 g/L Co, 1 M H 2 SO 4 ). The raffinate containing 58.4 g/L Co was submitted to a third circuit using a D2EHPA (0.6 M) + TBP (0.73 M) synergistic system operated at 50 °C. Zinc(II) was fully extracted by the D2EHPA + TBP system in 2 stages at pH 2 and O/A = 1:3, while Mn(II) and Cu(II) were fully extracted from the Zn-depleted raffinate in 2 stages at pH 3.5 and O/A = 2:1. The raffinate containing 58.3 g/L Co was deemed suitable for electrowinning. Copper(II), Mn(II), and Zn(II) were stripped out from the loaded D2EHPA + TBP in 3 stages at O/A = 2.5:1 using 1 M H 2 SO 4 . The real number of moles of extractants involved in the extractions and apparent equilibrium constants were estimated for all circuits. A flowsheet of the purification conceptual route is presented.
metallurgy & metallurgical engineering