Abstract:NiAl base eutectic alloy is an attractive material and promising to use in high temperature environment. However, the inadequate high temperature strength limits its application. In order to improve its strength, Zr was added in the Ti and Hf doped NiAl/Cr(Mo) base eutectic alloys and the effect of Zr addition on microstructure and mechanical properties of the eutectic alloy was investigated in this work. The results show that small addition of Zr can refine the NiAl/Cr(Mo) lamella inside the eutectic cell and optimize NiAl and Cr(Mo) phase morphology in the intercellular zone. Moreover, the Zr addition promotes the precipitation of bulk Heusler phase along eutectic cell boundary. With the increase of Zr addition, the eutectic cell of the alloys becomes fine, but the NiAl and Cr(Mo) phases in the intercellular zone become coarse and the Heusler phases exhibits semi-continuously distribution along the eutectic cell boundary. When the Zr content increases to 1% (atomic fraction), the NiAl and Cr(Mo) phases in eutectic cell and intercellular zone are all coarsened obviously. Additionally, coarse Cr-rich phases precipitate in the intercellular zone and Heusler phase forms the continuous network along eutectic cell boundary. The addition of Zr promotes the precipitation of coarse beta-NiAl and alpha-Cr phase in Cr(Mo) phase and NiAl phases, respectively. Moreover, the segregation of Heusler phase forming elements along the precipitate interface leads to the formation of a large number of interfacial dislocations. In addition, the addition of Zr results in the precipitation of fine Heusler particles in NiAl phase. It is shown that appropriate addition of Zr can improve the compression strength of Ni-33Al-28Cr-5.5Mo-1.0Ti-0.3Hf eutectic alloys significantly at room temperature and high temperature without reducing its compression plasticity, but more addition of Zr reduces the compressive plastic of the alloy inevitably.

Experimental determination of the Ni–Ni5Zr eutectic point for binary Ni–Zr alloy phase diagram

Experimental Investigation and Thermodynamic Assessment of the Mo–Ni–Zr Ternary System

EFFECT OF Zr ADDITION ON MICROSTRUCTURE AND MECHANICAL PROPERTIES OF NiAl/Cr(Mo)BASE EUTECTIC ALLOY

Phase Equilibria of the Ternary Ni-Cr-Zr System and Interfacial Reactions in the Ni-Cr/Zr Couples

Thermo-mechanical behavior of hypoeutectic Ni-Y-Zr alloys

Study of gradient eutectic structure changes and mechanical-corrosion properties of Zr–Fe binary alloys

Design Multicomponent Eutectic Alloys in the Co–Cr–Fe–Ni–Nb System Using Simple Mixing Method

Regulating microstructures and mechanical properties of Al-Fe-Ni alloys

Crystalline phases found in rapidly quenched Ni-Nb-Zr alloys

Effect of Zr addition on the microstructure, phase transformation and mechanical property of Ni 50 Mn 25 Ga 17 Cu 8 alloy

Redetermination of the Eutectic Composition of the Ni-P Binary Alloy

Microstructure and solidification behaviour of Ni3Al/Ni7Hf2 eutectic alloy

Experimental determination of phase diagram in the Zn-Fe binary system

Phase equilibria of the Co-Ni-Zr system at 1198 K

Optimizing Zr addition method to improve the comprehensive high temperature performance of Al-Fe-Ni-Sc eutectic alloy

Effect of Ni on Microstructures and Mechanical Properties for Multielemental Nb–Si-Based Alloys

Exploring Zr Influence on Microstructure and Mechanical Property in FeCoNiCrCuZr Eutectic High-Entropy Alloys

Effect of Zr Element Addition on the Mechanical Behavior of Ti48.5-Xni49.5nb2 Alloy

Experimental Investigation and Thermodynamic Verification for the Phase Relation around the ε-Mg23 (Al, Zn)30 Intermetallic Compound in the Mg-Zn-Al System

Microstructure-property relationship in Zr-alloyed Ni-rich NiTi alloys: Enhancements in high-temperature stability and superelasticity

Local Atomic Structure Correlating to Phase Selection in Undercooled Liquid Ni-Zr Peritectic Alloy