Abstract:Silica-based ceramic cores, with low coefficients of thermal expansion, low sintering temperatures, and excellent acid and alkali leaching capabilities, are essential materials for the production of hollow blades. However, their mechanical properties are suboptimal, and they present various processing challenges. In this study, silica-based ceramic cores were prepared using a combination of vacuum infiltration (VI) and laser powder bed fusion (LPBF) techniques. Al(OH) 3 was employed as a mineralizer to enhance the post-sintering mechanical properties and improve the efficiency of the vacuum infiltration process, thereby enhancing the overall performance of the silica-based ceramic cores. The VI process facilitated the penetration of nano-SiO 2 into the samples, increasing their density and promoting the formation of cristobalite during sintering at 1225°C. Additionally, the Al(OH) 3 powder, through pyrolysis into Al 2 O 3 during sintering, reduced microcracks, inhibited excessive cristobalite transformation, and improved the VI process, resulting in enhanced room-temperature flexural strength. By optimizing the Al(OH) 3 content and the VI process, significant improvements in the microstructure and properties of the silica-based ceramic cores were achieved. After three rounds of vacuum infiltration and the addition of 4 wt% Al(OH) 3 , the samples exhibited a high-temperature creep of 0.17 mm, with flexural strengths of 15.23 MPa at room temperature and 23.55 MPa at high temperature.

Development of Low Environmental Load Silica/Low Melting Point Alloy Composite Process and Evaluation of Solidified Material Properties

A low-temperature joining technology suitable for high-temperature applications developed by establishing chemical potential and supercooling gradients

Synthesis of Low Temperature Sintered Ferroelectric-Ferromagnetic Composite Materials

Physical Analysis of Solidifying Mechanism for Mixed Solidification Material with Silica Admixture and Blast Furnace Slag

Preparation And Properties Of Sintering-Free Low Density Si3n4/Sic Composite Refractory

Preparation, Microstructure, and Mechanical Properties of Spinel-Corundum-Sialon Composite Materials from Waste Fly Ash and Aluminum Dross

A solidification processing control method on the formation of metastable phases and its characteristics

An Improved Process for Solving the Sintering Problem of Al-Si Alloy Powder Metallurgy

A novel sintering additive system for porous mullite-bonded SiC ceramics: High mechanical performance with controllable pore structure

Low-Temperature Sintering of Coarse Alumina Powder Compact with Sufficient Mechanical Strength

Properties of a Reaction-Bonded Β-Sialon Ceramic Doped with an FeMo Alloy for Application to Molten Aluminum Environments

A novel composite binder design for direct ink writing alumina-based ceramics with enhanced strength at low sintering temperature

Novel fabrication process of AlN ceramic matrix composites at low temperatures

An Efficient Method to Engage Oxide Ceramics in Low-Temperature Interfacial Reactions:Microstructure Evolution and Kinetics Behaviors Based on Supercooling in a Transient Liquid Phase Bonding Joint

Facile synthesis of MgO–Mg2SiO4 composite ceramics with high strength and low thermal conductivity

Mechanical Properties of Ceramic–metal Composites by Pressure Infiltration of Metal into Porous Ceramics

Research on the Densification Process of the Mechanically-Alloyed Amorphous 2Si-B-3c-n Powder

Effect of Al(OH) 3 on the Properties of Silica-based Ceramic Cores Prepared by Laser Powder Bed Fusion Combined with Vacuum Infiltration

Inorganic microencapsulated core/shell structure of Al-Si alloy micro-particles with silane coupling agent

Polymer-derived SiHfN ceramics: From amorphous bulk ceramics with excellent mechanical properties to high temperature resistant ceramic nanocomposites

Sustainability in the Manufacturing of Eco-Friendly Aluminum Matrix Composite Materials