Abstract:We have attempted to apply the computer-based finite element analysis (FEA) method to accurately measure the mechanical properties (e.g., hardness and elasticity) of a soft material by an indentation test. First, an axisymmetric model has been developed using commercially available FEA code ANSYS. The FEA model consisted of a thin Al-film resting on Si-substrate. A spherical indenter has been used to indent the Al-film, which traveled a predefined depth during the loading and unloading cycles. First, numerical simulations were conducted to get the force vs. displacement plot, which was later used to determine the modulus of elasticity and hardness of Al-film. The effects of substrate modulus and indentation depth were thoroughly investigated to determine the modulus and hardness of Al-film. The effect of friction, considered at the interface of indenter and Al-film, was found to offer minimum impact for relatively small indentation depth. The induced force on the Al-film by the indenter has been found to be higher with increasing indentation depth when friction was considered. However the contact stiffness, represented by the slope of the unloading curve, has been found almost the same with and without considering friction. The variation of substrate modulus has been found to be ineffective to capture the Al-film modulus for relatively small indentation depth. However for higher indentation depth, the substrate modulus has been found to offer profound effect to capture the film modulus. The hardness of the Al-film has also been found to be relatively unaffected with variation of substrate modulus. However, the hardness of the Al-film has been found to be higher with friction for relatively high indentation depth. Results obtained from this preliminary research are important to continue further investigation and to characterize the mechanical properties of other soft-materials, e.g., biofilms to minimize its detrimental effects and utilize its favorable aspects in industrial and biomedical applications.

INFLUENCING THE INDENTATION CURVES BY THE BLUNTNESS OF THE BERKOVICH INDENTER AT THE FEM MODELLING

The Influence of Indenter Tip Imperfection and Deformability on Analysing Instrumented Indentation Tests at Shallow Depths of Penetration on Stiff and Hard Materials

The Effect of Indenter Angle on the Microindentation Hardness

Modeling Effect of Surface Roughness on Nanoindentation Tests

Friction Effect on Micro-indentation Measurement with Different Indenters

Influence of Indenter Tip Roundness on Hardness Behavior in Nanoindentation

Effect of the curvature for the indented solid with curved surface using flat punch indentation

Nano-Indentation for Characterizing Mechanical Properties of Soft Materials

The indenter tip radius effect in micro- and nanoindentation hardness experiments.

Numerical and Experimental Study of the Roughness Effects on Mechanical Properties of AISI316L by Nanoindentation

The Influence of Indenter Tip Radius on the Micro-Indentation Hardness

Study of Effect of Indenter Shape in Nanometric Scratching Process Using Molecular Dynamics

Effect of Surface Roughness on Nanoindentation Test of Thin Films

Finite Element Analysis of Nanoindentation Responses in Bi2Se3 Thin Films

Description of Unloading Behavior of Berkovich Nanoindentation

Measuring Poisson's ratio during nanoindentation via lateral contact stiffness; issues of slip and plasticity

On the Contact Area for Nanoindentation Tests with Berkovich Indenter: Case Study on Soda-Lime Glass

Analysis of the Nanoindentation Data Measured with a Berkovich Indenter for Brittle Materials: Effect of the Residual Contact Stress

Crystal plasticity assessment of the effect of material parameters on contact depth during spherical indentation

Indentation of Irreversibly Compressible Material: Computer Simulation

Quantitative Study of Roughness Effect in Nanoindentation on AISI316L Based on Simulation and Experiment