Abstract:Calculating disc cutter wear and predicting wear life are long-standing issues affecting the efficiency and cost of tunnel boring machines (TBMs). During the TBM excavation process, the wear of the disc cutter is a comprehensive outcome of the interaction between the tool and rock. Studying the mechanisms of tool rock breaking and wear can assist in developing a more precise model for predicting cutter wear. Therefore, based on the rock-breaking and wear mechanisms of a cutter, this study developed a model for predicting the cutter wear rate and life. The model is based on the theory of dense core–cavity expansion combined with the motion state of a cutter. First, the TBM excavation process and rock-breaking mechanism of a cutter were analyzed in detail. A cutting force model under the compression shear failure mode based on the dense core–cavity expansion theory was established. Based on the force model, a prediction model for the wear rate and life of the disc cutter was established, considering the working characteristics and wear mechanism. Furthermore, the impact of penetration on the prediction model was investigated. In addition, to demonstrate the practicality of the method, this study conducted a comprehensive examination using engineering examples. The results showed that the average difference in the cutter average wear rate using the developed model was less than 3% compared with the actual engineering result. In addition, the average difference in the wear life rate was less than 5%. Finally, the developed prediction method was compared with other models. The wear rate fitting accuracy was improved by 4.91–10.85% and the wear life fitting accuracy was improved by 5.11–12.19% by the developed method. This improvement confirms the reasonableness and reliability of the method. This method can estimate the wear rate and lifespan of a cutter more accurately and reliably than other methods, providing a practical tool to TBM engineers to make informed decisions and optimize tool replacement programs.

Effect of Spatial Variability on Disc Cutters Failure During TBM Tunneling in Hard Rock

Research on Numerical Simulation of Rock Breaking Using Tbm Disc Cutters Based on Udec Method

The energy method to predict disc cutter wear extent for hard rock TBMs

Experimental Study on Partial Wear of TBM Disc Cutter

Theoretical and Applied Research of the Deformation of the Continuous Cutterhead of TBM

Performance Evaluation of TBM Using an Improved Load Prediction Model

Study Of Surrounding Rock Damage Induced By Tunnel Boring Machine Driving Tunnel At West Route Of South To North Water Transfer Project

Prediction Model of TBM Disc Cutter Wear During Tunnelling in Heterogeneous Ground

Analysis on the Rock–Cutter Interaction Mechanism During the TBM Tunneling Process

Evaluation of TBM Cutter Wear in Granite and Developing a Cutter Life Prediction Model for Face Cutters Based on Field Data: A Case Study

Study of Rock-Cutting Process by Disc Cutters in Mixed Ground based on Three-dimensional Particle Flow Model

Tracking of disc cutter wear in TBM tunneling: a case study of Kerman water conveyance tunnel

Enhanced Wear Prediction of Tunnel Boring Machine Disc Cutters for Accurate Remaining Useful Life Estimation Using a Hybrid Model

Force and wear prediction model of disc cutter under compression shear failure mode based on dense core–cavity expansion theory (U-713)

Experimental Investigation on the Influence Factors on TBM Cutter Wear Based on Composite Abrasion Test

Spacing Optimization of the TBM Disc Cutter Rock Fragmentation, Based on the Energy Entropy Method

Preliminary identification of potential failure modes of a disc cutter in soil-rock compound strata: Interaction analysis and case verification

On the Loads for Strength Design of Cutterhead of Full Face Rock Tunnel Boring Machine

Experimental and numerical investigations on the force characteristics of cutter in different regions of the TBM cutterhead

Effects of Driving Parameters on TBM Dynamic Response and Cracking of the Disc Cutter Ring: A Case Study

Performance Evaluation of Hard Rock TBMs considering Operational and Rock Conditions