Abstract:The cutters on the cutterhead of a tunnel boring machine (TBM) are usually divided into center cutters, face cutters, and gage cutters, and have significantly different force characteristics. In this study, the authors conduct a series of full-scale cutter rotary cutting tests to compare the differences in the cutter force, the morphology of rock ships, and the efficiency of rock breaking. The results indicate that with increasing cutter spacing, the influence exerted by the cutters on one another in terms of their performance at breaking rocks decreases and their normal force gradually increases, while the rolling force of the cutters is less influenced by the spacing between them. The ratio of the normal force to the rolling force of the gage cutter is less than that of the face cutter, indicating a lower efficiency of breaking rock of the gage cutter. The ratio of rock chips with larger size (>50 mm) and smaller size (<10 mm) gradually decreases while that of rock chips with medium size (about 10–50 mm) gradually increases with increasing installation angle, such that the distribution of the particle size becomes more uniform. Excessive or insufficient penetration rate (PR) will increase the proportion of small rock chips, and a moderate PR will produce rock chips with a larger characteristic size and a more uniform size distribution. Then, a three-dimensional rock-breaking model by all cutters of actual TBM cutterhead is established based on the particle flow method. The results of the simulations indicate that the force on the inner ring of the center cutter is greater than that on the outer ring, and an increase in the installation radius weakens the load difference between the two rings. The normal and rolling forces of face cutters gradually increase, while their side force first increases and then decreases. The side force of the gage cutter significantly increases with the installation angle.

Theoretical and Applied Research of the Deformation of the Continuous Cutterhead of TBM

Research on Numerical Simulation of Rock Breaking Using Tbm Disc Cutters Based on Udec Method

Disc cutters’ layout design of the full-face rock tunnel boring machine (TBM) using a cooperative coevolutionary algorithm

Performance Evaluation of TBM Using an Improved Load Prediction Model

Dynamic Cutting Force Model and Vibration Analysis of the Cutterhead in TBM

Study Of Surrounding Rock Damage Induced By Tunnel Boring Machine Driving Tunnel At West Route Of South To North Water Transfer Project

Fragmentation Energy-Saving Theory of Full Face Rock Tunnel Boring Machine Disc Cutters

A New Calculation Model of Cutterhead Torque and Investigation of Its Influencing Factors

Experimental Study on Partial Wear of TBM Disc Cutter

Simulation of indentation behavior of TBM disc cutter and failure mechanism of hard rock assisted by hydraulic precutting kerfs

Study of Rock-Cutting Process by Disc Cutters in Mixed Ground based on Three-dimensional Particle Flow Model

Experimental and numerical investigations on the force characteristics of cutter in different regions of the TBM cutterhead

Experimental Investigation on the Influence Factors on TBM Cutter Wear Based on Composite Abrasion Test

Investigation on rock breaking and optimum spacing of TBM cutters under confining stress using a continuum-discontinuum method

On the Loads for Strength Design of Cutterhead of Full Face Rock Tunnel Boring Machine

Analysis on the Rock–Cutter Interaction Mechanism During the TBM Tunneling Process

Comparative Study of the Rock-breaking Mechanism of a Disc Cutter and Wedge Tooth Cutter by Discrete Element Modelling

Wear and abnormal fracture failure mechanisms of alloy teeth in TBM insert tooth disc cutters

Performance Evaluation of Hard Rock TBMs considering Operational and Rock Conditions

Numerical study on the rock breaking mechanism of high-pressure water jet-assisted TBM digging technique based on 2D-DEM modelling

Effect of Spatial Variability on Disc Cutters Failure During TBM Tunneling in Hard Rock