Abstract:Using hydroxypropyl terminated polydimethylsiloxane ( HP. PDMS ), isophorone diisocyanate and 2,2-bis( hydroxymethyl ) butyric acid as starting materials, silicone-polyurethane copolymer ( Si-PU ) latexes with particle diameter of about 50 nm were prepared via step-by-step feeding process followed by phase inversion technique in the absence of surfactant. Influences of the HP-PDMS content on the phase structure and the properties of the Si-PU latex films were investigated, and the difference between Si-PU and polyether polyurethane ( E-PU ) was emphasized. It was found that the content of PDMS in Si-PU could reach up to 65 wt%. Results of DSC analysis showed that, in comparison with the E-PU latex film, the Si-PU latex films exhibited well phase separation. Strong hydrogen bonding in Si-PU hard segments was confirmed by FTIR, which promoted the micro. phase separation in the latex films. On the contrary, strong hydrogen bonding existed in between the soft and hard segments in E-PU, which led to phase mixing and prevented the formation of phase separation structure. The Si-PU latex films were characterized by AFM tapping mode and the formation of sea. island phase separation was observed, and this kind of phase separation structure in the Si-PU latex films was rarely reported in the literature, in which the amorphous PDMS. enriched domains constituted the dispersed phases. With the increase in HP. PDMS content, the degree of phase separation in the Si-PU latex films increased as well, which led to the decrease of elastic modulus from 400.0 MPa to 32.2 MPa with an increase in elongation at break and in the flexibility. The initial decomposition temperature of the Si-PU latex films was at about 244 degrees C, which was 18 degrees C lower than that of the E-PU latex film due to the low degree of hydrogen bonding between the soft and the hard segments, whereas the thermal stability of Si-PU at high temperature zone was much better than E-PU. Compare to the E-PU latex film, a low water adsorption rate under 11% and a high contact angle above 94 degrees indicated excellent water resistance of the Si-PU latex films.

Effects of Polyether and Polyester Polyols on the Hydrophobicity and Surface Properties of Polyurethane/Polysiloxane Elastomers

Preparation and Properties of Epoxided Hydroxyl-terminated Polybutadiene Based Polyurethane Elastomers

Synthesis of CO2-Derived, Siloxane-Functionalized Poly(ether Carbonate)s and Waterborne Polyurethanes

Effect of soft segment structure on properties of polyurethane elastomers

Synthesis and Characterization of Eugenol‐based Silicone Modified Waterborne Polyurethane with Excellent Properties

Transparent polyester polyol-based polyurethane coatings: the effect of alcohols

Thermal stimuli response diphenylmethane diisocyanate‐based polyurethane elastomer via adjustable silicon‐induced distinctive microstructure

Synthesis, Characterization and Biocompatibility of Biodegradable Elastomeric Poly(ether-ester Urethane)s Based on Poly(3-hydroxybutyrate-co-3-hydroxyhexanoate) and Poly(ethylene Glycol) Via Melting Polymerization

Properties of Polyurethane Elastomers Based on Poly (Oxyethylene-Co-oxytetramethylene) Diol

Synthesis and modification of waterborne polyurethane derived from hybrid CO2-based polyols

Preparation and Surface Properties of Silicone-Modified Polyester-Based Polyurethane Coats

Enhanced Mechanical and Dielectric Properties of Polyurethane Elastomers Containing Modified SiO 2

Mechanical, Thermal, and Electrical Characterization of Polyethylene Glycol and PDI‐Based Polyurethane Films for Durable Antistatic Applications

Performance Study of Biodegradable Polyurethanes from Different Biodicarboxylic Acids and Their Potential Applications

Terpene derivative-containing silicone two-component waterborne polyurethane for coatings

Synthesis of diethylene glycol-based aliphatic polyester polyol and effect of glycerin crosslinker on its properties

Synthesis and Properties of Polyurethane Modified with Aminoethylaminopropyl Poly(dimethyl Siloxane)

Investigation on the Preparation of Silicone-polyurethane Latex, Phase Structure and Property of the Latex Films

Synthesis and physical property of sealant materials based on polyether polyol molecular weight and alkoxysilane for automobile structural parts

Effects of Isocyanate Structure on the Properties of Polyurethane: Synthesis, Performance, and Self-Healing Characteristics

Enhanced polyurethanes based on different polycarbonatediols