Abstract:HDPE geomembranes are usually used in bottom liners in landfills. Their integrity is required during installation and during the lifetime of the landfill. It is commonly accepted by researchers and suggested by different technical specifications that there should be no strain present during the installation of a geomembrane, although some of them propose that the strain during the installation should be no more than 3%. This is not easy to satisfy in some situations. Strains in the geomembranes can be induced by overnight temperature changes, before covering of the geomembrane (cold weather causes stretching of the geomembrane), which in turn may create trampoline effect in the veneer of sloped foundation soil. Covering of the geomembrane can wait higher temperatures to bring geomembrane into good close contact with the substructure profile or can be forced in order to bring the geomembrane into that position, which means accumulation of strains in the geomembranes. The question arises: What are the changes that occur in geomembrane properties for thermally and/or mechanically induced strains in the geomembranes, are they different, and how the level of induced strain and aging of strained geomembrane can change its properties? This paper presents a large project related to laboratory study of this phenomenon, and the first results regarding its short-time behaviour. Mechanical and structural changes of the geomembrane properties are tested and monitored in the first few days after inducing thermal and/or mechanical strains of 0%, 3% and 6%. Specially developed frames were used for the preparation and conditioning of the geomembrane samples. Test results suggest that strains induced by temperature drop and/or mechanical extension do not affect short-term geomembrane properties. Research continues on samples that will be monitored for four years.

Mechanical properties of PVC geomembrane under uniaxial tension based on non-contact measurement

Rate-Dependent Tensile Response of Polyvinyl Chloride Geomembranes

Mechanical properties analysis of architectural PVDF/PES fabrics with uni-tensile and bi-axial test

Experiments on Welded Seam Performances of C-type Fabric Membrane(PVC/PES)

Experiments on the mechanical properties and the welded seam properties of architectural membranes

Experimental studies on tear failure of PVC coated fabric

Experimental Study on Water Permittivity of Woven Polypropylene Geotextile under Tension

Shear models and parametric analysis of the PVC geomembrane-cushion interface in a high rock-fill dam

Mechanical behavior of PVDF membrane based on the uni-/bi-axial loading experiments

Study on Deformation Performance of Pvc Membrane Materials under Biaxial Cyclic Tensile Loads

Creep Failure Characteristics and Mathematical Modeling of High-Density Polyethylene Geomembranes under High Stress Levels

Constitutive Investigation on Viscoelasticity of PolyVinyl Butyral: Experiments Based on Dynamic Mechanical Analysis Method

The influence of thermally and mechanically induced short-term strains on smooth HDPE geomembrane properties

A multi-camera based photogrammetric method for three-dimensional full-field displacement measurements of geosynthetics during tensile test

Strength Characteristics of a Smooth HDPE Geomembrane/Nonwoven Geotextile Interface Based on a Novel Ring Shear Apparatus

Geomembrane Tensions and Strains Resulting from Differential Settlement Around Rigid Circular Structures

Geomembrane Strain Observed in Large-Scale Testing of Protection Layers

Characterizing viscoelastic properties of thin elastomeric membrane

Experimental study on mechanical properties of PVDF textile

Study on tensile performance of welded seams of PVC coated fabric membrane under uniaxial cyclic load

An Analysis of Tension of Geomembrane in Impervious Wall of Dam