Abstract:Cam-lobe radical-piston hydraulic motors can achieve ultrahigh power rotary output (up to megawatts), which are widely used in tunnel boring machines, dredgers, and other high-end equipment. In these applications, hydraulic motors always operate in complex and drastically changing conditions, causing their key roller-piston friction pairs to be vulnerable to wear and failure. However, there is a lack of easy-to-use and low-cost testing instruments to investigate the failure behavior of friction pairs and verify the reliability of the developed friction pairs. For that, this study developed a quasi-actual mechatronic instrument that can realistically reproduce various actual operating conditions to achieve quasi-actual testing of the friction pair. This instrument is composed of three parts: a testing bench, a hydraulic system, and a control system. The hydraulic system with a proportional relief valve is responsible for adjusting the hydraulic pressure on the piston in the testing bench, while the roller speed is controlled by a servo motor in the testing bench. To realize the quasi-actual control, an improved fuzzy PID and PI control algorithms embedded in the control system are proposed to real-time regulate the hydraulic pressure and roller speed, respectively. Finally, several quasi-actual testing experiments are conducted to reproduce different operating conditions of roller-piston friction pairs in a tunnel boring machine. The experimental results show that quasi-actual hydraulic pressures and roller speeds obtained from the developed mechatronic instrument are in good agreement with the actual operating data from the tunnel boring machine, indicating that the mechatronic instrument offers a feasible, easy-to-use, and quasi-actual way for testing roller-piston friction pairs.

Research and Application of Dynamic Torque Calibration for Torque Test Bench of Electric Actuator in Nuclear Power Plant

Research on the Modeling, Control, and Calibration Technology of a Tracked Vehicle Load Simulation Test Bench

Proposals for a practical calibration method for mechanical torque measurement on the wind turbine drive train under test on a test bench

Control method of multi-motor's speed synchronization control in dynamometer test bench for multi-axles'vehicle

Automatic Control System for a Torque Converter Static and Cycle Hydraulic Tester

The Development of the Static and Dynamic Performance Integrated Test System for Electro-hydraulic Servo Valve

Design and Modeling of a Test Bench for Dual-Motor Electric Drive Tracked Vehicles Based on a Dynamic Load Emulation Method

Development and Application of Steam Turbine Vibration Sensor Fault Diagnosis and Calibration Instrument

Loading Design for Comprehensive Performance Test Bench of Drive Axle Assembly

Research of System of Dynamic Torque Based on Virtual Instruments

A Calibration Strategy for EV Drives Based on Improved MTPV Table Decoupled from Permanent Magnet Flux Linkage Variation

Design and Calibration of Torque Measurement System of Comprehensive Performance Test Instrument of Industrial Robot Reducer

Influences on torque measurement in nacelle test benches and their effect on the measurement uncertainty and consequences of a torque calibration

Loading Methodology and Dynamics Analysis of the Digital-Servo Hydraulic Cylinders Group in Large Wind Turbine Drivetrain Test Bench

A Quasi-Actual Mechatronic Instrument for Realistically Testing Roller-Piston Friction Pairs

Development and Experimental Study of Dynamic Characteristics for Servo Valve Torque Motor

Study on the Control of AC Dynamometer System for Hybrid Electrical Vehicle Test Bench

Accuracy characteristics of the testing bench for dynamic transmission error

A Study on the Control System of AC Dynamometer

Development of a torque transducer applying a new elastic structure, and a vibration damping device based on the principle of eddy current brake

MAP Learning and Disturbance Observation Based Engine Torque Control for Dynamometer Test Bench