Abstract:This article introduces an innovative overmodulation approach based on the direct torque control with space vector modulation for surface‐mounted permanent magnet synchronous motor drives, which improves the tracking performance of the torque and flux linkage control. In comparison with the minimum phase error and minimum distance error strategies, the most unique feature of the proposed strategy is that the rotor angular position is required for the solution. Direct torque control with space vector modulation has been increasingly attracting emphasis for permanent‐magnet synchronous machine control, benefiting from a high dynamic response and low torque ripple. However, the rapid tracking performance of torque and stator flux linkage is gradually deteriorating as the machine enters the overmodulation region because of the output‐voltage limitation of the inverter. Therefore, to enhance the system tracking performance in the overmodulation region, an innovative overmodulation method based on torque and flux optimal tracking is proposed. In contrast to the conventional overmodulation method where only one of the torque and stator flux linkage tracking is considered, the proposed strategy first constructs the weightless cost function to achieve a trade‐off control between the torque and stator flux linkage. Then, by using an equivalent geometric path to intuitively express the weightless cost function, the minimum cost function can be easily solved and the optimal output voltage vector can be determined correspondingly, to achieve the fast‐tracking of both the torque and stator flux linkage. Additionally, the voltage utilization of different overmodulation schemes is also analysed. Finally, the experimental results demonstrate the efficiency and practicality of the proposed strategy.

A Calibration Strategy for EV Drives Based on Improved MTPV Table Decoupled from Permanent Magnet Flux Linkage Variation

Torque and Flux Weakening Control with MTPV for Interior Permanent Magnet Synchronous Motor

Maximum Torque Per Ampere Control of IPMSM Based on Online Parameter Identification Considering Cross-coupling and Saturation Effects

Deep Flux Weakening Control With Six-Step Overmodulation For A Segmented Interior Permanent Magnet Synchronous Motor

An Error Tracking Dead-beat Model Predictive Torque Control for Open-Winding Permanent Magnet Synchronous Motor with Common DC Bus

Power Perturbation Based Virtual Signal Injection Control of MTPA for IPMSM Drive System

Flux Weakening Control Of Interior Permanent Magnet Synchronous Machine To Improve Torque Performance

A V/Hz Based Maximum Torque Per Volt Control in Flux-Weakening Region for Interior Permanent Magnet Synchronous Motors

Maximum Torque Per Ampere (MTPA) Control Based on Online Calculation of Inductance Increment

A Virtual Signal Injection Based MTPV Control for IPMSM

A MTPA and Flux-Weakening Curve Identification Method Based on Physics-Informed Network without Calibration

A Novel Strategy of Control Performance Improvement for Six-Phase Permanent Magnet Synchronous Hub Motor Drives of EVs Under New European Driving Cycle

Sensorless Control Strategy of Novel Axially Magnetized Vernier Permanent-Magnet Machine

Three-Vector-Based Model Predictive Torque Control for a Permanent Magnet Synchronous Motor of EVs

Nonlinear Magnetic Model of IPMSM Based on the Frozen Permeability Technique Utilized in Improved MTPA Control

Accurate MTPA Strategy of PMSM Considering Cross Saturation Effect Based on Full-Flux-Linkage Model

MTPA Control and Flux-Weakening Control for IPMSM Drives Based on High-frequency Signal Injection

Research on MTPA Control Strategy of Permanent Magnet Synchronous Motor Based on Fast SVPWM Algorithm

Comparative Research of MTPA-FW Control Strategy for IPMSM Used in Electric Vehicles

MTPA Control Strategy for Six-phase DC-biased Hybrid Excitation Vernier Reluctance Machines

Dynamic overmodulation strategy based on torque and flux optimal tracking for DTC‐SVM of surface‐mounted PMSM drives