Abstract:To separate Mo(VI) and Zr(IV) ions from a 0.5 M oxalic acid solution and from each other, a novel macroporous silica-based N,N,N′,N′- tetraoctyl-3-oxapentane-1,5-diamide (TODGA) chelating polymeric adsorbent (TODGA/SiO 2 -P) was synthesized by introducing the TODGA molecule into ca. 50-μm diameter SiO 2 -P particles by impregnation. The adsorption of Mo(VI) and Zr(IV) ions onto TODGA/SiO 2 -P was investigated by examining the influence of nitric acid and oxalic acid concentrations. It was found that the adsorption was strongly affected by increasing the HNO 3 concentration from 0.5 M to 9.0 M either with or without the addition of 0.5 M H 2 C 2 O 4 . In the absence of 0.5 M H 2 C 2 O 4 , the distribution coefficients (K d ) of both Mo(VI) and Zr(IV) ions decreased with an increase in the HNO 3 concentration from 0.5 M to 3.0 M, increased slowly when the concentration of HNO 3 was increased further from 3.0 M to 6.0 M, and then increased gradually above 6.0 M concentration. Furthermore, the adsorption of Zn(IV) ions onto TODGA/SiO 2 -P was considerably greater than that of Mo(VI) ions. In the presence of 0.5 M H 2 C 2 O 4 , Zr(IV) ions showed no adsorption at HNO 3 concentrations below 4.0 M, being partly adsorbed in the presence of 4.0–6.0 M HNO 3 and fully adsorbed when the HNO 3 concentration was greater than 6.0 M. In contrast, Mo(VI) ions showed a much lower adsorption at HNO 3 concentrations below 2.0 M and no adsorption above this acid level. In the presence of HNO 3 at a concentration above 6.0 M and containing 0.5 M H 2 C 2 O 4 , the adsorption of Zr(IV) ions overlapped that from a similar HNO 3 solution which did not include 0.5 M H 2 C 2 O 4 . This was attributed to complete protonation of the C 2 O 2− 2 anion. On the basis of batch experiments, Mo(VI) and Zr(IV) ions were separated from a 6.5 M HNO 3 solution containing 0.5 M H 2 C 2 O 4 by means of a column packed with TODGA/SiO 2 -P at 50°C. The separate components, Mo(VI) and Zr(IV), could be effectively separated from each other by eluting with some selected eluants. The recovery percentage was 100.5% for Mo(VI) ions and 96.8% for Zr(IV) ions.

CYANEX 925 As Potential Extractant For the Extraction and Separation of Zirconium (IV) And Niobium (V) From nitric acid Solution

Investigations on the use of commercial phosphonic acid derivative for the extraction and separation of Zr(IV) and Nb(V) from their admixture in nitric acid solution

Properties and Mechanism of Molybdenum and Zirconium Adsorption by a Macroporous Silica‐Based Extraction Resin in the MAREC Process

Adsorption and Chromatographic Separation of Mo(VI) and Zr(IV) Ions from a High-Concentration Oxalic Acid Solution by a Macroporous Silica-Based N,N,N′,N′-Tetraoctyl-3-Oxapentane-1,5-Diamide Polymeric Adsorbent

Synthesis of a Novel Silica‐Based Macroporous Polymer Containing TODGA Chelating Agent and Its Application in the Chromatographic Separation of Mo(VI) and Zr(IV) from Diethylenetriaminepentaacetic Acid

Extraction of Cesium and Some Typical Metals with a Supramolecular Recognition Agent 1,3-Bis(1-nonyloxy)-2,4-crown-6-calix[4]arene

HYDROXYLAMINE DERIVATIVE IN PUREX PROCESS. VI. STUDY ON THE PARTITION OF URANIUM/NEPTUNIUM AND URANIUM/PLUTONIUM WITH N,N-DIETHYLHYDROXYLAMINE IN THE PURIFICATION CYCLE OF URANIUM CONTACTOR

Solvent extraction of lanthanides and yttrium from nitrate medium with CYANEX 925 in heptane

Liquid-liquid extraction of niobium(V) in the presence of other metals with high molecular mass amines and ascorbic acid

STUDIES THE CRUCIAL ROLE OF SELECTION OF EXTRACTANT TO EXTRACT NIOBIUM FROM SULFURYL FLUORIDE SOLUTION AND OPTIMIZATION OF EXTRACTION CONDITIONS

Extraktion von Elementen mit Dithizon und Diethylammonium-N,N′-diethyldithiocarbamat aus flußsauren Lösungen und ihre Anwendung in der Analyse von Niob

Separation and extraction of niobium from H2SO4 solution containing titanium and iron impurities

Extraction and complex formation of niobium(V) with 3-hydroxy-2-methyl-1-(4-tolyl)-4-pyridone

A novel method for the separation of niobium and titanium from sulfuric acid-oxalate solutions using N235 and MIBK

Separation of niobium from chloride media by solvent extraction with dicyclohexyl-18-crown-6

Potential Fast and Promising Separation for Valuable Ions of Biomedical Interest

Solvent extraction technology for the separation and purification of niobium and tantalum: A review

Isolation of Zirconium and Niobium from Fission Products by Solvent Extraction with Dilute TBP

Optimal Extraction and Separation of Europium and Samarium from Nitrate Medium Using Binary Mixture of Cyanex 572 and Tertiary Amine Extractants