Abstract:Palladium has long been explored for use in gas sensors because of its excellent catalytic properties and its unique property of forming hydrides in the presence of H2. However, pure Pd-based sensors usually suffer from low response and a relatively high limit of detection. Palladium nanosheets (PdNS) are of particular interest for gas sensing applications due to their high surface area and excellent electrical conductivity. Here, we demonstrate the design and fabrication of low-cost PdNS-based dual gas sensors for room-temperature detection of H2 and CO over a wide concentration range. We fabricated sensors using multiwalled carbon nanotube@PdNS (MWCNT@PdNS) composites and compared their performance against pure PdNS devices for hydrogen sensing based on electrical resistive response. Devices using PdNS alone had a response and response time of 0.4% and 50 s, respectively, to 1% H2 in air. MWCNT@PdNS (1:5 mass ratio) showed enhanced performance at a lower hydrogen concentration with a limit of detection (LODH2) of 5 ppm. Nearly an order of magnitude increase in response was observed on increasing the amount of MWCNT to 50 mass % in the nanocomposite, but the response fell off at low H2 concentration. Overall, these PdNS-based sensors were found to show good repeatability, stability, and performance under humid conditions. Their response was selective for H2versus CH4, CO2, and NH3; the response to CO was comparable in magnitude but opposite in sign to the response to H2. Upon simultaneous exposure to equal concentrations (10 ppm each) of H2 and CO, the response to CO was dominant. The PdNS showed high sensitivity to CO, detecting as little as 1 ppm CO in air at room temperature. The sensitivity to CO could be used either in a stand-alone room-temperature CO detector, where H2 is known not to be present, or in combination with CO and combustible gas detectors to distinguish H2 from other combustible gases.

Palladium-Doped Tin Oxide Nanosensor for the Detection of the Air Pollutant Carbon Monoxide Gas

Highly Sensitive, Ambient Temperature CO Sensor using Tin Oxide based Composites

Gas Absorption Detection of Carbon Monoxide and Hydrogen Based on Tin Dioxide Nanopowder

Highly sensitive carbon monoxide (CO) gas sensors based on Ni and Zn doped SnO 2 nanomaterials

Resistive-type VOCs and pollution gases sensor based on SnO2: A review

Carbon Materials-Functionalized Tin Dioxide Nanoparticles Toward Robust, High-Performance Nitrogen Dioxide Gas Sensor

Sensitive, selective and stable tin dioxide thin-films for carbon monoxide and hydrogen sensing in integrated gas sensor array applications

Porous SnO 2 nanoflowers derived from tin sulfide precursors as high performance gas sensors

Visible Light Driven Ultrasensitive and Selective NO 2 Detection in Tin Oxide Nanoparticles with Sulfur Doping Assisted by l ‐Cysteine

Gas Sensors Based on SnO2 Nanomaterials toward Hazardous Gases Detection

Formation of Highly Porous Gas-sensing Films by In-situ Thermophoretic Deposition of Nanoparticles from Aerosol Phase

Palladium Nanosheet-Based Dual Gas Sensors for Sensitive Room-Temperature Hydrogen and Carbon Monoxide Detection

High Response CO Sensor Based on a Polyaniline/SnO2 Nanocomposite

A Highly Sensitivity and Selectivity Pt-SnO2 Nanoparticles for Sensing Applications at Extremely Low Level Hydrogen Gas Detection

SnO2/rGO nanocomposite for the detection of biomarkers of lung cancer

Sensitivity and Selectivity of SnO2-Based Sensor for CO and H2 Detections: A Novel Method to Detect Simultaneously the CO and H2 Concentrations

Conductometric ppb-Level CO Sensors Based on In2O3 Nanofibers Co-Modified with Au and Pd Species

Enhancing the CO2 sensor response of nickel oxide-doped tin dioxide thin films synthesized by SILAR method

Carbon Monoxide Gas Sensing Properties of Metal-Organic Frameworks-Derived Tin Dioxide Nanoparticles/molybdenum Diselenide Nanoflowers

Highly Sensitive Carbon Monoxide Sensor Element with Wide-Range Humidity Resistance by Loading Pd Nanoparticles on SnO2 Surface