Investigation and fabrication of nano-sized SnO2 powder and its gas sensing properties
Yinghui Wei,Minqi Yao,Hongli Guo,Lanqing Hu,Lifeng Hou,Bingshe Xu
2006-01-01
Abstract:Nano-sized SnO2 powder can be fabricated by the sol-gel method and analyzed by means of XRD, TEM, etc. The results show that the grain size of SnO2 is less than 100nm, in which the sintering temperature has a great influence. When the sintering temperature is lower than 500 degrees C, the grain size has good heat stability, however when the temperature is higher than 500 degrees C, the grain size of SnO2 will grow due to the increase in temperature. The sensor made of this powder has good gas sensing properties and the response and reversion time are 8s and 20s respectively. The optimum working current is 170mA, while the sensor has high sensitivity to some gases, especially CH4. The environment around us, either global or local, is becoming worse due to chemical pollutants and as a consequence of the ever increasing activity of human beings around the world. In the past, major attention has been paid to typical air pollutants which cause a green-house effect, ozone layer destruction, acid rain and so on. Now, the atmosphere contains a variety of artificially produced chemical components, as well as the apprehension of other effects by pollutants which has increased recently. Therefore, it is necessary to analyze and control these gases. Semiconductor detecting methods are an economical and effective way. At present, SnO2, a surface-controlled sensor, is the main type of gas sensing materials used in the world. The use of SnO2 is prompted by the finer grain and the higher surface ratio, the more obvious change of conductance and the higher sensitivity. Compared with traditional materials, nano-sized materials are composed of superfine particles and more atoms in surfaces and boundaries, therefore nano-sized materials off on many excellent properties. Nano-sized materials offer effective prospects in sensing materials field(2). Using nano-sized powder materials will improve the gas sensing properties of SnO2 semiconductors.