Abstract:An equiatomic CoCrFeMnNi high-entropy alloy, which crystallizes in the face-centered cubic (fcc) crystal structure, was produced by arc melting and drop casting. The drop-cast ingots were homogenized, cold rolled and recrystallized to obtain single-phase microstructures with three different grain sizes in the range 4–160μm. Quasi-static tensile tests at an engineering strain rate of 10−3s−1 were then performed at temperatures between 77 and 1073K. Yield strength, ultimate tensile strength and elongation to fracture all increased with decreasing temperature. During the initial stages of plasticity (up to ∼2% strain), deformation occurs by planar dislocation glide on the normal fcc slip system, {111}〈110〉, at all the temperatures and grain sizes investigated. Undissociated 1/2〈110〉 dislocations were observed, as were numerous stacking faults, which imply the dissociation of several of these dislocations into 1/6〈112〉 Shockley partials. At later stages (∼20% strain), nanoscale deformation twins were observed after interrupted tests at 77K, but not in specimens tested at room temperature, where plasticity occurred exclusively by the aforementioned dislocations which organized into cells. Deformation twinning, by continually introducing new interfaces and decreasing the mean free path of dislocations during tensile testing (“dynamic Hall–Petch”), produces a high degree of work hardening and a significant increase in the ultimate tensile strength. This increased work hardening prevents the early onset of necking instability and is a reason for the enhanced ductility observed at 77K. A second reason is that twinning can provide an additional deformation mode to accommodate plasticity. However, twinning cannot explain the increase in yield strength with decreasing temperature in our high-entropy alloy since it was not observed in the early stages of plastic deformation. Since strong temperature dependencies of yield strength are also seen in binary fcc solid solution alloys, it may be an inherent solute effect, which needs further study.

Temperature Dependent Solid Solution Strengthening in the High Entropy Alloy CrMnFeCoNi in Single Crystalline State

Elevated-temperature Deformation Mechanisms in a CrMnFeCoNi High-Entropy Alloy

High temperature tensile and creep properties of CrMnFeCoNi and CrFeCoNi high-entropy alloys

THE INFLUENCE OF CHEMICAL COMPOSITION ON SOLID SOLUTION AND STRAIN HARDENING OF SINGLE CRYSTALS OF FCC HIGH-ENTROPY ALLOYS

Creep Behaviour and Microstructural Evolution of AlxCrMnFeCoNi High-Entropy Alloys

Creep behaviour and microstructural evolution of Al x CrMnFeCoNi high-entropy alloys

The Effects of Refractory Elements on Mechanical Properties in CoCrNiFe Concentrated Solid Solution Alloys Across Different Temperatures

Preparation and properties of FeNiMnCuC0.2Alx high-entropy alloy

The influences of temperature and microstructure on the tensile properties of a CoCrFeMnNi high-entropy alloy

Tensile creep properties of a CrMnFeCoNi high-entropy alloy

Deformation mechanisms of Al0.1CoCrFeNi at elevated temperatures

Long-Term Creep Behavior of a CoCrFeNi Medium-Entropy Alloy

High-Temperature Mechanical Behavior of Cobalt-Free FeMnCrNi(Al) High-Entropy Alloys

Tensile creep behavior and mechanism of CoCrFeMnNi high entropy alloy

Precipitation and decomposition in CoCrFeMnNi high entropy alloy at intermediate temperatures under creep conditions

On the Solidification and Phase Stability of a Co-Cr-Fe-Ni-Ti High-Entropy Alloy

Towards Superior High Temperature Properties in Low Density AlCrFeNiTi Compositionally Complex Alloys

High-Temperature Tensile Strength of Al10Co25Cr8Fe15Ni36Ti6 Compositionally Complex Alloy (High-Entropy Alloy)

Intermediate-Temperature Creep Deformation and Microstructural Evolution of an Equiatomic FCC-Structured CoCrFeNiMn High-Entropy Alloy

Effects of temperature on mechanical properties and deformation mechanisms of the equiatomic CrFeNi medium-entropy alloy

The Effect of Heat Treatment on the Microstructure and Mechanical Properties of Al0.6CoFeNi2V0.5 High Entropy Alloy