Abstract:A cavity nucleation model under creep-fatigue interaction, abbreviated as CH model, has been established. The key aspect of the CH model is accounting for the creep deformation through a self-consistent scheme. This allows the combined effect of grain boundary sliding (GBS) and crystal deformation on cavity nucleation to be assessed in Type 316 stainless steel over the temperature range of 500-600 degrees C. The CH model predicts that the local normal stress asymptotically approaches a non-zero saturation value over a long period of stress hold. This aligns with the continuous nucleation process under creep. The CH model has been used to calculate the cavity nucleation rates under various load-waveform scenarios, which include the stress and time applied during the transient and steady loadings. As a result, the load waveform characteristics that can maximise the cavity nucleation are identified. First, the pre-compressive hold time needs to be long, whereas the load reversal time needs to be short. Second, the tensile hold time can be shortened to some extent if time efficiency is the primary concern. Third, all the above-mentioned time-related parameters have their optimum values depending on the temperature and creep rate. Fourth, the unbalanced stress hold in favour of the tension enhances the nucleation rate, and the stress range is the controlling factor. In summary, the CH model provides an important guide to the design of creep-fatigue testing programme with the desire to promote creep cavitation damage. This mechanistic-based model provides underlying interpretations to the complexity of creep-fatigue interaction.

The Role of Grain Boundary Orientation and Secondary Phases in Creep Cavity Nucleation of a 316H Boiler Header

Investigation of Grain Misorientation on Creep Void Nucleation in P91 Heat-Resistant Steel by Experimentation and Crystal Plasticity Simulation

Characterization of Multiaxial Creep Behaviors of 16MND5 Steel at Pre- and Post-phase Transformation

Low Cycle Fatigue and Creep Fatigue Interaction Behavior of 9Cr-0.5Mo-1.8w-v-nb Heat-Resistant Steel at High Temperature

Creep Behavior and Deformation Mechanism of a Third-Generation Single Crystal Ni-Based Superalloy at 980 °C

Unveiling the Microstructure Evolution and the Short-Time Tensile Creep Behavior in the CuCrZr Alloy

Experimental and Numerical Study on Multiaxial Creep Behavior of 16MND5 Steel at 700℃

Experimental Method for Creep Crack Growth Testing in Controlled Environments at High Temperatures

Modelling of a Grade 91 power plant pressurised header weldment under ultra super-critical creep conditions

Combined crystal plasticity and grain boundary modeling of creep in ferritic-martensitic steels: I. Theory and implementation

Multiscale correlative tomography: an investigation of creep cavitation in 316 stainless steel

Creep behavior and in-depth microstructural characterization of dissimilar joints

Creep Behavior and Cavitation Evolution of 15crmog Steel at High Temperatures

Numerical Simulation of Void Growth Induced Creep Rupture in HAZ at Elevated Temperature

Characterisation of the creep cavitation process on grain boundaries in a polycrystalline nickel-base alloy 247

Modelling of Cavity Nucleation under Creep-Fatigue Interaction

Creep behavior analysis on ruptured welds of heat-resistant steels with two different failure modes

Experimental Investigation on Creep Behaviors and Life Prediction Across Phase-Transformation of Thermal Aged 16MND5 Steel

Creep-Fatigue Crack Initiation Simulation of a Modified 12% Cr Steel Based on Grain Boundary Cavitation and Plastic Slip Accumulation

Coarsening Behavior of Grain Boundary M23C6 in Inconel 740H During Creep

Correlation of Creep Fracture Lifetime with Microstructure Evolution and Cavity Behaviors in G115 Martensitic Heat-Resistant Steel