Abstract:A supercritical carbon dioxide (S-CO2) and Organic Rankine Cycle (ORC) combined cycle has been considered to fully use the residual heat of a high temperature heat source in this paper. The topping cycle is a S-CO2 recompression cycle, and the bottoming cycle is an ORC with R245fa as the working fluid. Compared with previous studies, the influence of several additional parameters, including the S-CO2 recompression cycle main compressor inlet temperature and pressure and the S-CO2 recompression cycle split ratio, has been conducted. It indicates that the split ratio plays an important role on the S-CO2 recompression cycle, even on the combined cycle. A thermodynamic optimization method which considers the split ratio is proposed to maximum the combined cycle thermal efficiency. By this method, more than 4.1% increment on the thermal efficiency can be attained. INTRODUCTION The supercritical carbon dioxide (S-CO2) is a special kind of CO2 fluid whose temperature and pressure are higher than its critical values (304.13K, 7.38 MPa). The S-CO2 cycle, which uses S-CO2 as the working fluid, is considered to be one of the most promising power generation technologies for the future (Feher, 1968). The S-CO2 cycle has higher efficiency and more compact system and components than conventional power cycles, especially in the high temperature range. Besides, CO2 is easy to obtain and the S-CO2 cycle system has high safety level. It is widely acknowledged that the S-CO2 cycle is applicable for various heat sources, such as the nuclear energy (Moisseytsev and Sienicki, 2009), concentrated solar power (Turchi and Ma, 2012), fuel cell (Xia et al., 2019) and waste heat recovery (Song et al., 2018a). One of the S-CO2 cycle characteristics is that the specific heat capacity of the cold side flow is much higher than that of the hot side in recuperators. For the S-CO2 recompression cycle, the CO2 flow is split to compensate for the specific heat difference in the low temperature recuperator and to further enhance the heat recuperation in the high temperature recuperator. Therefore, the residual heat is decreased and the S-CO2 recompression cycle has higher efficiency than simple recuperated cycle. The S-CO2 recompression cycle has been adopted by National Energy Technology Laboratory (NETL) of U.S. DOE for Supercritical Transformational Electric Power (STEP) program (Lambruschini et al., 2016).

Supercritical Carbon Dioxide(s-CO2) Power Cycle for Waste Heat Recovery: A Review from Thermodynamic Perspective

Performance Analysis and Evaluation of a Supercritical CO2 Rankine Cycle Coupled with an Absorption Refrigeration Cycle

Preliminary Conceptual Exploration about Performance Improvement on Supercritical CO2 Power System Via Integrating with Different Absorption Power Generation Systems

Investigation of Engine Waste Heat Recovery Using Supercritical CO2(S-CO2) Cycle System

Thermodynamic Analysis of Coal-Fired Thermal Power Units Coupled S-CO2 Energy Storage System

Thermodynamic Modelling, Technical and Operational Issues of Supercritical Carbon Dioxide Power Generation Cycles for Industrial Applications: A Literature Review

A systematic review of supercritical carbon dioxide(S-CO2) power cycle for energy industries: Technologies, key issues, and potential prospects

Thermodynamic Analysis of Supercritical Carbon Dioxide Cycle for Internal Combustion Engine Waste Heat Recovery

Recent Progress on High Temperature and High Pressure Heat Exchangers for Supercritical CO2 Power Generation and Conversion Systems

Thermoeconomic Analysis Of Optimization Potential For Co2 Vapor Compression Cycle: From Transcritical To Supercritical Operation For Waste Heat Recovery From The Steam Condenser

Comparative investigation on the supercritical carbon dioxide power cycle for waste heat recovery of gas turbine

Thermodynamic Analysis and Optimization of a Supercritical Carbon Dioxide (S-CO2) Recompression Cycle Coupled with a Bottoming Organic Rankine Cycle

Thermodynamic analysis and parametric optimization of a novel S–CO2 power cycle for the waste heat recovery of internal combustion engines

Performance improvement of supercritical carbon dioxide power cycles through its integration with bottoming heat recovery cycles and advanced heat exchanger design: A review

THERMODYNAMIC ANALYSIS AND SYSTEM DESIGN OF THE SUPERCRITICAL CO2 BRAYTON CYCLE FOR WASTE HEAT RECOVERY OF GAS TURBINE

Analysis of CO2-based trans-critical power cycle in waste heat recovery

Dynamic Modeling and Control of Supercritical Carbon Dioxide Power Cycle for Gas Turbine Waste Heat Recovery

A review of research on turbines for supercritical carbon dioxide power systems

Research on Off-Design Characteristics and Control of an Innovative S-CO2 Power Cycle Driven by the Flue Gas Waste Heat

Qualitative Assessment and Global Mapping of Supercritical CO2 Power Cycle Technology

Evaluation and optimization of supercritical cycles using CO 2 based mixtures as working fluids: A thermodynamic study