Abstract:In this study, the process of carbon dioxide (CO2) capture directly from ambient air in a conventional monoethanolamine (MEA) absorption process was simulated and optimized using a rate-based model in Aspen Plus. The process aimed to capture a specific amount (148.25 Nm3/h) of CO2 from the air, which was determined by a potential application aiming to produce synthetic methane from the output of a 2.7 MW electrolyser (593 Nm3/h H2). We investigated the technical performance of the process by conducting a sensitivity analysis around different parameters such as air humidity, capture rate defined as a ratio of moles of CO2 captured during the process to the total mole of CO2 in the feed stream, CO2 loading of lean and rich absorption liquids and reboiler temperature, and evaluated the energy consumption and overall cost in this system. In order to meet the design requirement for standard packed columns, the rich absorption liquid was circulated to the top of the absorber. A capture rate of 50% was selected in this process as a baseline. At higher capture rates, the required energy per ton of captured CO2 increases due to a higher steam stripping rate, required in the desorber, and at lower capture rates, the size of equipment, in particular, absorber and blowers increases due to the need for processing a significantly larger volume of air at the given CO2 production volume. At the base case scenario, a reboiler duty of 10.7 GJ/tCO2 and an electrical energy requirement of 1.4 MWh/tCO2 were obtained. The absorber diameter and height obtained were 10.4 and 4.4 m, respectively. The desorber is found to be relatively small at 0.54 m in diameter and 3.0 m in height. A wash water section installed at top of the absorber decreased the MEA loss to 0.28 kg/ton CO2. However, this increased capital cost by around 60% resulting in CO2 capture costs of $1,691 per ton CO2 for the MEA base scenario. Based on the techno-economic analysis, assuming a non-volatile absorbent rather than MEA thereby avoiding a wash water section, and using an absorption column built from cheaper materials, the estimated cost per ton of CO2 produced was reduced to $676/tCO2. The overall cost range was between $273 and $1,227 per ton of CO2 depending on different economic parameters such as electricity ($20–$200/MWh) and heat price ($2–$20/GJ), plant life (15–25 years) and capital expenditure (±30%). In order to reduce the cost further, the use of innovative cheap gas-liquid contactors that operate at lower liquid to gas ratios is crucial.

Energy-efficiency analysis of industrial CO2 removal system using nanoabsorbents

CO2 Removal from Air by Hollow-fiber Membrane-based Absorption System

The use of nanoparticles for high-efficiency CO2 capture by methanol

Multi-stage Solvent Circulation Absorption Enhancement: System Optimization for Energy-Saving CO2 Capture

Research on Modern CO2 Absorption Process

A Coupling Calculation Method of Desorption Energy Distribution Applied to CO2 Capture by Chemical Absorption

Energy Efficient Absorbents For Industry Promising Carbon Dioxide Capture

Multi-stage solvent circulation absorption enhancement: System optimization for energy-saving CO 2 capture

Absorption Solubility Calculation and Process Simulation for CO2 Capture

Pilot-Scale Experimental Study of a New High-Loading Absorbent for Capturing CO2 from Flue Gas

Experimental study on the performance of a highly efficient NE‐1 absorbent for CO2 capture

Absorption solubility calculation and process simulation for CO; capture

Determining the Performance of an Efficient Nonaqueous CO2 Capture Process at Desorption Temperatures below 373 K

Techno-Economic Assessment for CO2 Capture From Air Using a Conventional Liquid-Based Absorption Process

Experimental And Rate-Based Modeling Study Of Co2 Capture By Aqueous Monoethanolamine

Field demonstration of a 10 MW CO 2 capture pilot plant in extended operation using KoSol absorbents for treating off-gas in a coal fired power plant

On co 2 absroprtion using absorbent in hollow fiber membrane contactor

Energy, Exergy, and Economic Analysis of a Low-Energy Consumption CO2 Capture System with Ionic Liquid [DEME][TF2N]

Process Simulations of CO2 Desorption in the Interaction between the Novel Direct Steam Stripping Process and Solvents

Experimental Study of the Absorption and Regeneration Performance of Several Candidate Solvents for Post-Combustion CO2 Capture

Mathematical Modelling and Experimental Investigation of CO2 Absorber Recovery Using an Electro-Acidification Method