Abstract:A larger (6.1 L) MFC stack made in a scalable configuration was constructed with four anode modules and three (two-sided) cathode modules, and tested at a wastewater treatment plant for performance in terms of chemical oxygen demand (COD) removal and power generation. Domestic wastewater was fed either in parallel (raw wastewater to each individual anode module) or series (sequentially through the chambers), with the flow direction either alternated every one or two days or kept fixed in a single direction over time. The largest impact on performance was the wastewater COD concentration, which greatly impacted power production, but did not affect the percentage of COD removal. With higher COD concentrations (similar to 500 mg L-1) and alternating flow conditions, power generation was primarily limited by the cathode specific area. In alternating flow operation, anode modules connected to two cathodes produced an average maximum power density of 6.0 +/- 0.4 W m(-3), which was 1.9 +/- 0.2 times that obtained for anodes connected to a single cathode. In fixed flow operation, a large subsequent decrease in COD influent concentration greatly reduced power production independent of reactor operation in parallel or serial flow modes. Anode modules connected to two cathodes did not consistently produce more power than the anodes connected to a single cathode, indicating power production became limited by restricted anode performance at low CODs. Cyclic voltammetry and electrochemical impedance spectroscopy data supported restricted anode performance with low COD. These results demonstrate that maintaining power production of MFC stack requires higher influent and effluent COD concentrations. However, overall performance of the MFC in terms of COD removal was not affected by operational modes. (C) 2016 Elsevier Ltd. All rights reserved.

Comparative study of different hydro-dynamic flow in microbial fuel cell stacks

A novel pilot-scale stacked microbial fuel cell for efficient electricity generation and wastewater treatment.

Stacked all-graphite microfluidic microbial fuel cells

Electrochemical Study of Multi-Electrode Microbial Fuel Cells under Fed-Batch and Continuous Flow Conditions

Effect of Electricity on Microbial Community of Microbial Fuel Cell Simultaneously Treating Sulfide and Nitrate

The Effect of Fl Ow Modes and Electrode Combinations on the Performance of a Multiple Module Microbial Fuel Cell Installed at Wastewater Treatment Plant

Design mining microbial fuel cell cascades

Multiparameter optimization of microbial fuel cell outputs using linear sweep voltammetry and microfluidics

Scalable microbial fuel cell (MFC) stack for continuous real wastewater treatment.

From single-chamber to multi-anodic microbial fuel cells: A review

Parameters affecting the performance of anaerobic baffled stacking microbial fuel cell

Comparison of anodic microbial communities in parallel-operated microbial fuel cells

Scale-up and stack performance of single-chamber microbial fuel cells with activated carbon air cathodes

Improved Performance of Microbial Fuel Cells Enriched with Natural Microbial Inocula and Treated by Electrical Current

Optimization of catalyst dosage and total volume for extendible stacked microbial fuel cell reactors using spacer

Evaluation of different cell-immobilization strategies for simultaneous distillery wastewater treatment and electricity generation in microbial fuel cells

A Paper‐based Self‐pumping Microfluidic Fuel Cell Stack with a Novel Vertical Structure

Comparison of the effect of microbial fuel cell connectivity on power generation efficiency

A high performance membraneless microfluidic microbial fuel cell for stable, long-term benchtop operation under strong flow

Optimization of Microbial a Fuel Cell with Linear Sweep Voltammetry and Microfluidics

New architecture for modulization of membraneless and single-chambered microbial fuel cell using a bipolar plate-electrode assembly (BEA)