Abstract:A larger (6.1 L) MFC stack made in a scalable configuration was constructed with four anode modules and three (two-sided) cathode modules, and tested at a wastewater treatment plant for performance in terms of chemical oxygen demand (COD) removal and power generation. Domestic wastewater was fed either in parallel (raw wastewater to each individual anode module) or series (sequentially through the chambers), with the flow direction either alternated every one or two days or kept fixed in a single direction over time. The largest impact on performance was the wastewater COD concentration, which greatly impacted power production, but did not affect the percentage of COD removal. With higher COD concentrations (similar to 500 mg L-1) and alternating flow conditions, power generation was primarily limited by the cathode specific area. In alternating flow operation, anode modules connected to two cathodes produced an average maximum power density of 6.0 +/- 0.4 W m(-3), which was 1.9 +/- 0.2 times that obtained for anodes connected to a single cathode. In fixed flow operation, a large subsequent decrease in COD influent concentration greatly reduced power production independent of reactor operation in parallel or serial flow modes. Anode modules connected to two cathodes did not consistently produce more power than the anodes connected to a single cathode, indicating power production became limited by restricted anode performance at low CODs. Cyclic voltammetry and electrochemical impedance spectroscopy data supported restricted anode performance with low COD. These results demonstrate that maintaining power production of MFC stack requires higher influent and effluent COD concentrations. However, overall performance of the MFC in terms of COD removal was not affected by operational modes. (C) 2016 Elsevier Ltd. All rights reserved.

Scale-up and stack performance of single-chamber microbial fuel cells with activated carbon air cathodes

Scale-up of Membrane-Free Single-Chamber Microbial Fuel Cells

Evaluating a Multi-Panel Air Cathode Through Electrochemical and Biotic Tests

Effects of hydraulic pressure on the performance of single chamber air-cathode microbial fuel cells

Increasing Power Generation for Scaling Up Single-Chamber Air Cathode Microbial Fuel Cells.

Scaling up self-stratifying supercapacitive microbial fuel cell

Tubular Membrane Cathodes for Scalable Power Generation in Microbial Fuel Cells.

Microbial fuel cells with an integrated spacer and separate anode and cathode modules

Scaling Up a Novel Denitrifying Microbial Fuel Cell with an Oxic-Anoxic Two Stage Biocathode

A novel pilot-scale stacked microbial fuel cell for efficient electricity generation and wastewater treatment.

Air-cathode structure optimization in separator-coupled microbial fuel cells.

Performance Assessment of Multi-Electrodes Reactors for Scaling-up Microbial Fuel Cells

The Effect of Fl Ow Modes and Electrode Combinations on the Performance of a Multiple Module Microbial Fuel Cell Installed at Wastewater Treatment Plant

Scalable air cathode microbial fuel cells using glass fiber separators, plastic mesh supporters, and graphite fiber brush anodes.

Air-cathode preparation with activated carbon as catalyst, PTFE as binder and nickel foam as current collector for microbial fuel cells.

Increased Power Generation in a Continuous Flow MFC with Advective Flow Through the Porous Anode and Reduced Electrode Spacing

Power Generation by Packed-Bed Air-Cathode Microbial Fuel Cells

Parameters affecting the performance of anaerobic baffled stacking microbial fuel cell

Modification of carbon based cathode electrode in a batch-type microbial fuel cells

Increased Performance of Single-Chamber Microbial Fuel Cells Using an Improved Cathode Structure

Long-term performance of activated carbon air cathodes with different diffusion layer porosities in microbial fuel cells