Abstract:A larger (6.1 L) MFC stack made in a scalable configuration was constructed with four anode modules and three (two-sided) cathode modules, and tested at a wastewater treatment plant for performance in terms of chemical oxygen demand (COD) removal and power generation. Domestic wastewater was fed either in parallel (raw wastewater to each individual anode module) or series (sequentially through the chambers), with the flow direction either alternated every one or two days or kept fixed in a single direction over time. The largest impact on performance was the wastewater COD concentration, which greatly impacted power production, but did not affect the percentage of COD removal. With higher COD concentrations (similar to 500 mg L-1) and alternating flow conditions, power generation was primarily limited by the cathode specific area. In alternating flow operation, anode modules connected to two cathodes produced an average maximum power density of 6.0 +/- 0.4 W m(-3), which was 1.9 +/- 0.2 times that obtained for anodes connected to a single cathode. In fixed flow operation, a large subsequent decrease in COD influent concentration greatly reduced power production independent of reactor operation in parallel or serial flow modes. Anode modules connected to two cathodes did not consistently produce more power than the anodes connected to a single cathode, indicating power production became limited by restricted anode performance at low CODs. Cyclic voltammetry and electrochemical impedance spectroscopy data supported restricted anode performance with low COD. These results demonstrate that maintaining power production of MFC stack requires higher influent and effluent COD concentrations. However, overall performance of the MFC in terms of COD removal was not affected by operational modes. (C) 2016 Elsevier Ltd. All rights reserved.

New architecture for modulization of membraneless and single-chambered microbial fuel cell using a bipolar plate-electrode assembly (BEA)

Microbial fuel cells with an integrated spacer and separate anode and cathode modules

Electricity Generation Using a Baffled Microbial Fuel Cell Convenient for Stacking.

A Novel Configuration of Microbial Fuel Cell Stack Bridged Internally Through an Extra Cation Exchange Membrane

From single-chamber to multi-anodic microbial fuel cells: A review

Continuous Flowing Membraneless Microbial Fuel Cells with Separated Electrode Chambers

A novel pilot-scale stacked microbial fuel cell for efficient electricity generation and wastewater treatment.

Increased Power Generation in a Continuous Flow MFC with Advective Flow Through the Porous Anode and Reduced Electrode Spacing

Enhanced Biofilm Distribution and Cell Performance of Microfluidic Microbial Fuel Cells with Multiple Anolyte Inlets

Scale-up of Membrane-Free Single-Chamber Microbial Fuel Cells

A new strategy for improving MFC power output by shared electrode MFC–MEC coupling

Tubular Membrane Cathodes for Scalable Power Generation in Microbial Fuel Cells.

Different Electrode Configurations to Optimize Performance of Multi-Electrode Microbial Fuel Cells for Generating Power or Treating Domestic Wastewater

Scalable air cathode microbial fuel cells using glass fiber separators, plastic mesh supporters, and graphite fiber brush anodes.

Stacked all-graphite microfluidic microbial fuel cells

Microbial Fuel Cells: the Effects of Configurations, Electrolyte Solutions, and Electrode Materials on Power Generation

The Effect of Fl Ow Modes and Electrode Combinations on the Performance of a Multiple Module Microbial Fuel Cell Installed at Wastewater Treatment Plant

A Membrane Electrode Assembly Typed Microbial Fuel Cell for Electricity Generation

Ion Exchange Membrane Cathodes For Scalable Microbial Fuel Cells

Increasing Power Generation for Scaling Up Single-Chamber Air Cathode Microbial Fuel Cells.

Heterogeneity in microbial fuel cell stacking influences acidogenic metabolism towards bioelectricity generation, fatty acid synthesis and wastewater treatment