Investigation of the effect of cobalt on the Ni–Al2O3 catalyst prepared by the mechanochemical method for CO2 methanation

Parisa Shafiee,Seyed Mehdi Alavi,Mehran Rezaei
DOI: https://doi.org/10.1007/s11164-022-04700-1
IF: 3.134
2022-03-19
Research on Chemical Intermediates
Abstract:Various Ni–Co catalysts supported on alumina were produced by the mechanochemical technique and applied to CO2 Methanation. X-ray diffraction, temperature-programmed reduction with H2 (H2–TPR), and nitrogen physisorption were used to characterize the produced catalysts. The results of investigating three active phase percentages of Ni–Co, including 10%, 15%, and 20%, showed that the activity of Ni-based catalysts was affected with the cobalt addition. The introduction of Co improved the dispersion of Ni particles in the catalyst, and the incorporation of cobalt into the Ni–Al2O3 caused a decline in the surface area and an increase in crystal size. The effect of adding equal amounts of 5, 10, and 15% Co to 5 N, 10 N, and 15 N was also investigated in this study. The changes in the molar ratios of Ni/Co had a remarkable effect on the performance of the catalyst at temperatures from 200 to 500 °C. From our results on the effect of adding an equal amount of 5, 10, and 15% Co to 5 N, 10 N, and 15 N, it can be concluded that the 10N10C catalyst is more active than 10Ni while 5N5C and 15N15C showed lower activities than 5 N and 15 N.
chemistry, multidisciplinary
What problem does this paper attempt to address?