Abstract:Vehicles commonly suffer from the narrow-band noises and vibrations, usually a superposition of multiple sinusoidal signals, due to the excitations of engines, electrical motors, gear boxes, and other rotating mechanical parts. These excitations are transmitted to a reference point of some structure with certain transmission paths. The vibration signal measured at the reference point can be used for power system monitoring, fault diagnosis, modal analysis, noise analysis, etc. For convenience, researchers in a laboratory usually use shakers to generate expected narrow-band vibration signals acting on the vehicle structure reference points to simulate the vibration signals. However, there is a prominent difficulty in ensuring the amplitude and phase accuracy of each sub-frequency component simultaneously. In order to improve the accuracy of generating the expected vibration signal, this paper presents a multi-source vibration simulation control technology based on the tracking filter method. The main idea is to use the tracking filter to estimate the amplitude and phase of the target sub-frequency component accurately. Further, on the target sub-frequency, the drive signal of shakers is then corrected based on the amplitude and phase errors to achieve a more accurate target vibration signal. The amplitude and phase of each sub-frequency component in the excitation signal can be controlled independently. Compared with other Fast Fourier Transform (FFT)-based frequency domain analysis algorithms and numerical methods by solving the equations, the tracking filter method has a higher frequency resolution and higher accuracy. It can be easily realized in real time applications due to its simplicity. Finally, verification experiments are completed. The experimental results show that the multi-source vibration simulation control technology presented in this paper can achieve high-precision amplitude and phase on each sub-frequency component of the target vibration signals, which contain up to eight sub-frequency components.

Simulation and Experimental Verification of Sweep Frequency Vibration Fatigue for Motor Controller of Integrated Electric Drive System for Electric Vehicle

Research on load model of VF based motor drive

FEA-Based Mathematical Modeling and Simulation for IPMSM Drive with Consideration of Saturation and Cross-Coupling Influence

On Static Load Model of Variable Frequency Based Motor Drive

Research On Control Technologies For A High-Precision Multi-Source Vibration Simulation System

A Vibration Mitigation Approach for Inverter-fed Permanent Magnet Motor Drive System

A novel control strategy for vibration reduction in the permanent magnet motor drive system with eccentric load

Improving Vibration Performance of Electric Vehicles Based on In-Wheel Motor-Active Suspension System Via Robust Finite Frequency Control

Transient analysis of PWM inverter-fed AC motor drives using finite element method coupling with external circuit model

Study on Vehicle Fatigue Simulation Test Using Adaptive Control

CFD simulation analysis optimization and experimental verification of heat dissipation problem of electric vehicle motor controller

Optimized Controller for Electrostatic Force Feedback Micro Accelerometers

Vertical Vibration Analysis on Electric Vehicle with Suspended In-Wheel Motor Drives

Control System and Flux-weakening Algorithm of Electric Vehicle

Finite Element Method Modal Analysis of Driving Motor for Electric Vehicle

Optimization and Finite-Frequency H∞ Control of Active Suspensions in In-Wheel Motor Driven Electric Ground Vehicles

Event-Triggered Adaptive Fault Tolerant Sliding Mode Control for FWID-EV

Simulation, Verification and Optimization Design of Electromagnetic Vibration and Noise of Permanent Magnet Synchronous Motor for Vehicle

Design and Verification of Motor Direct-driven Actuator for FES

An Integrated Vibration Elimination System with Mechanical-Electrical-Magnetic Coupling Effects for In-Wheel-Motor-Driven Electric Vehicles

Design of Automobile Gear Fatigue Test System Based on Servo Control