Abstract:Measuring magnetic flux density in actual motor systems and understanding the influence of power harmonics on iron loss are urgent challenges under variable frequency drive (VFD) power supply conditions, and this research is studied based on the classical Bertotti's three constant coefficient model. An iron loss model incorporating various harmonic voltages is established by substituting the amplitude and frequency of voltage for magnetic density amplitude and considering the effects of output harmonic voltage by the VFD. The voltage waveform was measured under a VFD power supply and decomposed via Fourier analysis to determine the amplitude of each harmonic voltage. The iron loss coefficients are solved using the least squares method. The iron loss and harmonic iron loss are calculated and analyzed with and without filtering under different frequencies and voltage conditions. Experimental results indicated that iron loss increases with the increase of voltage, frequency, and magnetic flux. The harmonic iron loss increased with the voltage and magnetic flux at low frequencies. While the harmonic iron loss decreased as voltage and magnetic flux increased at high frequencies. The iron loss is significantly higher than in sine-driven ones in pulse width modulation VFD-driven spindle motors, and harmonic iron loss took up a proportion of at least 20% of the total iron loss. This research not only offers a precise method to predict the iron loss of high-speed spindle motors but also reveals the pattern of iron loss variation, providing a theoretical basis for motor design and optimization.

Research on load model of VF based motor drive

On Static Load Model of Variable Frequency Based Motor Drive

Adaptability Research of the Dynamic Equivalent Model of Variable Frequency Drive Motors

Load Modeling with Considering Frequency Characteristic

Composite Load Models Based on Field Measurements and Their Applications in Dynamic Analysis

Load Modeling Including Air Conditioners

Parameters identification of practical load model with voltage phase considered

Comparison of three composite induction motor load models

FEA-Based Mathematical Modeling and Simulation for IPMSM Drive with Consideration of Saturation and Cross-Coupling Influence

Influence of Load Models in Sending and Receiving Ends of Henan Power Grid on Tie-line Stability Limit of Sending End

Practical Induction Motor Model with Consideration of Frequency Variation

Load Modeling for Wide Area Power System

A Composite Induction Motor Load Model for Conversion Between Different Voltage Sides Through the Transmission Element

Novel Simplified Model for Asynchronous Machine with Consideration of Frequency Characteristic

Analytic Formulae for Estimating Motor Proportion of Load Model under Small Disturbance

Modeling and Simulation of Non-Linear Dynamic Process of the Induction Motor System with Fluctuating Potential Loads

A Low-order Simplified Model of Power-electronic-interfaced Loads

Experimental research on iron loss of high-speed spindle motor under variable frequency drive power supply

Research of V/f Control Method for Multiphase Induction Motor with Non-sinusoidal Supply at Low Speed

Investigation of Analytical Models for Surface-Mounted Permanent Magnet Motor Using Voltage Source Inverter

Electric Load Modeling Based on Characteristic Fusion