Abstract:The present study investigates the adoption of laser surface treatments to improve the bonding strength of dissimilar material hybrid structures made by the thermomechanical joining process. Aluminium AA7075 alloy was joined to Polyether-ether-ketone through a friction-assisted joining process. For the surface treatment, a two-step laser treatment was adopted. The latter consists of a first phase, called laser texturing, where a deep square grid texture is obtained by adopting high pulse energy and repetitions, followed by a further laser treatment, called cleaning, carried out with lower energy content, and applied over the overall adhesion surface. Two textures characterised by different grid sizes (200 and 300 µm) were realised. As received, uncleaned, and only cleaned samples were adopted as reference treatments. The results indicated that laser cleaning performed after laser texturing enabled a significant improvement of adhesion irrespective of the previous laser texturing strategy. This was also confirmed by the higher amount of polymer trapped within the laser-texturized paths. The only laser cleaning treatment enabled the successful joining of the substrates with an average shear strength of 12 MPa. On the other hand, when texturing with a hatch distance of 200 μm, laser cleaning performed after texturing increased the shear strength from 18.4 MPa to 25.2 MPa corresponding to an increase of 37%. The increased adhesion between the PEEK and the aluminium was also indicated by the change in the failure mode of the joints. The texturized samples with a hatch distance of 200 μm failed by pull-out; when the laser cleaning was performed on these samples, they failed by cohesive failure.

Direct Bonding of Polymer and Metal with an Ultrahigh Strength: Laser Treatment and Mechanical Interlocking

Surface treatment and solvent co-assisted easy direct bonding of polymer/metal

Experimental and numerical investigation on the strength of polymer-metal hybrid with laser assisted metal surface treatment

Mechanism of laser-inducing hierarchical surface structures improving bonding strength of metal-plastic hybrids

Enhanced interfacial bonding strength between metal and polymer via synergistic effects of particle anchoring and chemical bonding

Achieving green and ultra-strong bonding between metals and polymers through additive manufacturing

Improving bonding strength of aluminium-PEEK hybrid metal-polymer joints by two-step laser surface treatment

Pin-Shaped Surface Structures Generated by Laser Single Pulse Drilling for High-Strength Interfaces in Thermally Joined Polymer–Metal Hybrids

Effect of Metal Surface Topography on the Interlaminar Shear and Tensile Strength of Aluminum/Polyamide 6 Polymer-Metal-Hybrids

Forming Epoxy Coatings on Laser-Engraved Surface of Aluminum Alloy to Reinforce the Bonding Joint with a Carbon Fiber Composite

Role of Metal Surface Amorphization on Enhancing Interfacial Bonding in TC4-UHMWPE Hybrid Structure

The Effects of Combined Treatments of Laser Engraving, Plasma Spraying and Resin Pre-Coating on Improving the Bonding Strength of Titanium Alloy and Carbon Fiber-Reinforced Polymer

Improving the interfacial bonding strength and suppressing shrinkage porosity of 6061Al/GFRTP hot-pressing joints via interfacial modification

Enhancing Bond Strength Between Carbon Fiber Reinforced Thermoplastic and Aluminum Alloys Through Laser Surface Treatment

Interface needle structure induced high-performance aluminum alloy/PPS hybrids

Physicochemical interactions between amorphous metal oxide and polymer in metal–polymer hybrid materials

Surface Treatments for Enhancing the Bonding Strength of Aluminum Alloy Joints

Experimental and Theoretical Investigation of Laser Pretreatment on Strengthening the Heterojunction Between Carbon Fiber Reinforced Plastic and Aluminum Alloy.

Micro-nano interfacial mechanical interlocking structure-property of the ultrasonic-assisted hot press molded polypropylene/aluminum alloy hybrid

Interlayer bonding improvement of PEEK and CF-PEEK composites with laser-assisted fused deposition modeling

Hybrid Laser Technique for Joining of Polymer and Titanium Alloy