Abstract:Powder bed fusion (PBF) is an additive manufacturing technique capable of fabricating highly complex, individualised, and lightweight polymer components. However, to maximise the potential of PBF, in terms of both economic efficiency and environmental sustainability, a successful powder re-use strategy is essential. During a build, ageing and degradation processes affect the re-usability of un-sintered powder, so used powder is usually refreshed with virgin material before re-use. This study considers the effectiveness of using a 70:30 refresh ratio in a specific PBF technique: laser sintering (LS). Across a total of seven printing cycles, polyamide-12 (PA-12) powder refreshed with 30% virgin material after each build, revealed a 4.5°C increase in melting temperature. There was also a 20% reduction in particle flowability, which may be related to the presence of fine satellite particles and considerable particle cracking. This deterioration in powder quality resulted in a 5.8% increase in total part porosity, and an 11% reduction in the ultimate tensile strength of fabricated parts, over the seven build cycles. A Pearson correlation test quantified that the reduction in powder flowability was the most significant (p-value of 0.005) cause for the loss of part strength; emphasising that the revolution powder analyser could be a useful complimentary technique for determining the quality of used powder within laser sintering. Nonetheless, compared to previous studies which re-used 100% aged PA-12 powder, without refreshing with any virgin material, the observed reduction in part strength is relatively modest. This suggests that a 70:30 refresh ratio offers a good compromise between maintaining part performance, particularly for non-critical applications, without having to add an unnecessary amount of virgin powder. Therefore, this study reveals the relationship between the deterioration of powder properties and reductions in part strength; yet highlights the benefits of operating with a 70:30 refresh ratio when re-using PA-12 powder across multiple build cycles.

A technical review of the challenges of powder recycling in the laser powder bed fusion additive manufacturing process

Research progress of the metal powder reuse for powder bed fusion additive manufacturing technology

Characterization, preparation, and reuse of metallic powders for laser powder bed fusion: A review

Laser Powder Bed Fusion of Powder Material: A Review

Material Reuse in Laser Powder Bed Fusion: Side Effects of the Laser—Metal Powder Interaction

Numerical investigation on the reuse of recycled powders in powder bed fusion additive manufacturing

Influence of the physicochemical properties of reusable powders on the mechanical properties of Ti6Al4V manufactured via laser powder bed fusion additive manufacturing

The effects of powder reuse on the mechanical response of electron beam additively manufactured Ti6Al4V parts

Maraging steel powder recycling effect on the tensile and fatigue behavior of parts produced through the laser powder bed fusion (L-PBF) process

Laser Powder Bed Fusion: A State-of-the-Art Review of the Technology, Materials, Properties & Defects, and Numerical Modelling

Effective Ti-6Al-4V Powder Recycling in LPBF Additive Manufacturing Considering Powder History

Assessment of trapped powder removal and inspection strategies for powder bed fusion techniques

Re-use of polyamide-12 in powder bed fusion and its effect on process-relevant powder characteristics and final part properties

Laser Powder Bed Fusion: A Review on the Design Constraints

Developing Four Powder Recycling Strategy for Sustainable Additive Manufacturing 3D Printing Process

Strategies for metallic powder reuse in powder bed fusion: A review

The Quest for the Holy Grail Of 3D Printing: A Critical Review of Recycling in Polymer Powder Bed Fusion Additive Manufacturing

In situ monitoring the effects of Ti6Al4V powder oxidation during laser powder bed fusion additive manufacturing

Laser powder bed fusion for metal additive manufacturing: perspectives on recent developments

Powder recycling effects on porosity development and mechanical properties of Hastelloy X alloy during laser powder bed fusion process