Generic Tool path planning method of T-spline surface CNC milling

Li Rui,Jie Chen,Xin Liu,Yan Yang,Xin Hu,Jin-Quan Li

DOI: https://doi.org/10.1088/1742-6596/1748/6/062033

2021-01-01

Journal of Physics: Conference Series

Abstract:Abstract T-spline is a new surface modeling technology, which has superior advantages in complex shape representation over traditional NURBS and mesh surfaces. However, the research in CAM field is insufficient, which hinders the further promotion of this technology. To fit the complex topology of T-spline surface, a general tool path planning method of T-spline surface CNC milling is proposed based on the commonly used zig-zag or contour-parallel toolpath pattern. This method utilizes the 2-dimensional scallop height model to calculate side step, the iso-scallop height method to generate tool paths, the minimum energy method to smooth them, and Hermite curves to join them as one tool path, which can realize the milling of T-spline surface model with arbitrary topology. Finally, a T-spline CAM prototype system is successfully developed to implement simulation analysis and machining experiments to verify the algorithms above. And the results of simulations and experiments prove this method can generate a smooth tool path with uniform iso-scallop height distribution, short length, smooth corner transition, and one retraction, which can achieve better finish machining effect.

What problem does this paper attempt to address?

The problem that this paper attempts to solve is the deficiencies in the T - spline surface NC milling tool path planning method in the field of computer - aided manufacturing (CAM). Specifically, existing T - spline surface machining methods such as the space - filling curve method will lead to frequent changes in tool orientation, which is not desirable in actual machining. In addition, the tool paths generated by these methods are long, and the cutting height distribution is uneven, affecting the machining effect.

To overcome these problems, the author proposes a general T - spline surface NC milling tool path planning method. This method is based on the commonly used zig - zag or contour - parallel tool path patterns and is implemented through the following steps:

1. **Lateral step evaluation**: Calculate the lateral step using a two - dimensional scallop - height model.
2. **Equal scallop - height tool path generation**: Generate a tool path with equal scallop - height.
3. **Tool path smoothing**: Smooth the tool path based on the minimum - energy method.
4. **Tool path connection**: Connect the tool paths into a continuous path using Hermite curves.

Through this method, shorter and smoother tool paths can be generated, and the number of corner turns can be reduced, making the scallop - height distribution more uniform, thereby improving the machining effect and efficiency. The paper verifies the effectiveness of this method through simulation experiments, and the results show that compared with existing methods, this method has significant improvements in terms of path length, number of corner turns, and scallop - height distribution.