Abstract:This study presents a novel roller piston pump,in which a cam guide-roller type rolling support is adopted to replace the sliding pair support of the swash plate-slipper pair to achieve the oil suction and discharge of the piston cavity.In addition,the shaft distribution is used to replace the original valve plate distribution and the driving shaft is used as the distribution shaft to remove the valve plate structure,which greatly simplifies the design of the axial piston pump.Such a configuration largely reduces the number of sliding friction pairs of the pump,and avoids the influence of the sliding friction pair on it under high-speed and variable-speed conditions.Firstly,mathematical models of the mechanical and volumetric efficiencies of the roller pump are deduced respectively through force analysis and the compressibility equation.Based on the numerical simulation of MATLAB and AMESim,the effects of load pressure and rotational speed on mechanical and volumetric efficiencies are studied respectively,and it is verified that the roller pump has no structural flow pulsation.The prototype pump is then designed and built,along with a special test rig.The outlet pressure,outlet flow,and torque of the pump under different load pressures and rotational speeds are measured,and the mechanical and volumetric efficiencies of the prototype pump under various load pressures and rotational speeds are obtained.The experimental results are in good agreement with the simulated analysis.When the load pressure is 8 MPa and the speed is 5000 r/min,the mechanical and the volumetric efficiencies are 85.5%and 96.8%,respectively.When the speed is increased to 10000 r/min,the mechanical and the volumetric efficiencies are 66.7%and 95.6%,respectively.The experimental results show that the proposed roller piston pump has excellent efficiency under wide-speed and high-speed conditions and can be a potential solution as a fuel pump in aerospace fuel systems.

Discussion on the factors affecting the pump efficiency of screw pump

Research and Application of Systematic Lift Techology for Screw Pump in Deviated Well

Affecting Factor Analysis of system efficiency of high freezing point and high viscosity crude oil pumping well

The Optimization of A Low Specific Speed Pipeline Pump

Optimization of Bellows in Bellows Pumps for Higher Pumping Efficiency

Development and Application of a New Double Action Oil Well Pump

The Mechanism Performance of Improved Oil Pump with Micro-Structured Vanes

An Optimization Method for Clearance Value of Electric Submersible Screw Pump

Development and Application of Double Action Rod Pump

Energy Consumption Analysis and Optimization of Electric Submersible Pump System

IMPORTANT MEASURE OF RAISING SYSTEM EFFICIENCY OF PUMPING WELL

Rational Matching Injection and Production Pump for Rod Pump Injection-Production Systems

Low Leakage and High Volumetric Efficiency Research of Seawater Plunger Pump

Performance Research and Structure Optimization of Labyrinth Screw Pump

Current Situation and Outlook for R&D of Dry Screw Vacuum Pumps

Theoretical study on the pressurization characteristics of disc-seal single screw pump used in high viscosity oily sludge conveying field

Theoretical and Experimental Investigation of Pressure Generation within Twin-Screw Pump for Multiphase Transport

Influence of surface texture parameters of screw pump rotor on tribological properties of its friction pairs

Theoretical and Experimental Investigation on the Efficiency of a Novel Roller Piston Pump

Review and optimization of main parameters of pump turbine in Xiangshuijian pumped-storage power station

Development of an Oil Free Water-Lubricated Twin-Screw Air Compressor