Abstract:The oil-free compressor is a key component in fabricating polyethylene terephthalate (PET) bottles for beverages and water. At present, the main compressor type used for blowing PET bottles is the reciprocating compressor. However, compared to screw compressors, reciprocating compressors have shortcomings of high energy consumption and too many consumable parts. Many manufacturers of PET bottles in Asia are seeking to replace reciprocating compressors with screw compressors, as we know. Screw compressors can be classified as single-screw compressors (SSC) and twin-screw compressors. Since the load in a twin-screw compressor is far larger than that in an SSC, SSCs are more suitable for being developed for high-pressure applications such as PET bottle blowing. This paper presents a performance study on an oil-free single-screw compressor as the first stage of the PET compressor unit. A 5.4 m(3)center dot min(-1)prototype and its test rig were developed. The thermophysical process of the moist air is theoretically analyzed. The pressure loss on the flow path and the influence of the important parameters are experimentally investigated. It is found that water vapor cannot be separated during the adiabatic compression process. The results also show that the pressure loss from the discharging duct to the check valve accounts for the largest percentage of the total pressure loss. The experimental results further show that the discharge capacity and shaft power increase almost linearly with the motor speed. The efficiency declines with increasing injected water temperature. The discharge capacity and shaft power all increase with the injected water flowrate, and an optimum flowrate is found to ensure a highest isentropic efficiency. With the increase in discharge pressure, the discharge capacity decreases, and the shaft power increases. The isentropic efficiency is found to have its maximum value at a certain discharge pressure.

Development of an Oil Free Water-Lubricated Twin-Screw Air Compressor

Energy-saving Technology and Experimental Research of Reciprocating Compressor

Simulation of High Speed Oil-free Twin-screw Compressor in Fuel Cell

Research on Heat and Mass Transfer Characteristics of Water Lubricated Twin-screw Air Compressor

Experimental Research on Indicator Diagrams of a Water Lubricated Screw Air Compressor

Development of Experiment Rig for Lubricate Film of the Slipper-pad in Axial Piston Pumps

Simulation of the Characteristics of the Water-Lubricated Journal Bearing in Twin-Screw Air Compressor

Experimental Study of the Oil Injection Screw Air Compressor

Experimental Investigation of the Water–injected Process-Gas Screw Compressor

Development And Experimental Study Of The First Stage In A Two-Stage Water-Flooded Single-Screw Compressor Unit For Polyethylene Terephthalate Bottle Blowing System

Refreshed Internal Working Characteristics of the Single Screw Compressor Based on Experimental Investigation

Experimental and Simulated Investigation of Lubrication Characteristics of a Water-Lubricated Bearing in a Single-Screw Compressor

Analysis of the leakage in a water-lubricated twin-screw air compressor

Experimental Study of Lubricating Oil Impact on Pressure Pulsation for Twin-Screw Refrigeration Compressor

Research and Development on Design Theory and Key Technology of Screw Compressors

Research on Power Consumption Distribution Characteristics of a Water-Lubricated Twin-Screw Air Compressor for Fuel Cell Applications

Development and Experimental Study of a High-Efficiency Helium Twin-Screw Compressor

Study on the friction characteristics of a self-lubricating linear compressor using vapor injection{fr}Étude des caractéristiques de frottement d'un compresseur linéaire auto-lubrifié utilisant l'injection de vapeur.

Experimental Investigation into the Effect of Oil Injection on the Performance of a Variable Speed Twin-Screw Compressor

Experimental Study of Heat Transfer Effect on Oil-Free Scroll Air Compressor

Experimental Study on the Performance Characteristics of Air Screw Compressor under Unloading Condition