Self-assembled Monolayers Enhance the Performance of Oxide Thin-Film Transistors
Wensi Cai,Zhigang Zang,Liming Ding
DOI: https://doi.org/10.1088/1674-4926/42/3/030203
2021-01-01
Abstract:Thin-film transistors (TFTs) based on oxide semiconductors have gained a lot of attention in applications such as displays and sensors particularly in recent years due to the advantages of oxide semiconductors like high mobility, good uniformity over large area and low deposition temperature[1−4]. However, the defects/traps at dielectric/channel interface and top surface of oxide TFTs might dramatically degrade device performance including current on/off ratio, mobility and most importantly stability[5, 6], making it quite urgent to systematically make effective interface engineering to improve TFT performance. Traps on the top channel surface are mainly caused by the adsorbed water and oxygen molecules from air[7], which could be reduced by applying a passivation layer. One effective passivation layer is organic self-assembled monolayer (SAM), which can be formed densely on the surface of oxide semiconductors through the reaction with –OH groups, ensuring a reliable interface coupling between SAM and the channel layer and hence a good chemical stability[5, 8]. Compared with conventional inorganic passivation layers, SAMs can be easily applied on the top channel surface via vaporor solution-based methods[8−10], which are plasma-free processes and can avoid the potential plasma damage to oxide semiconductors. SAMs with different functional groups might give very different surface energy and dramatically affect the resulting device performance, especially the stability and hysteresis. Recently, Kim et al. investigated InGaZnO (IGZO) TFTs treated by SAMs with CH3, NH2 and CF3 functional groups, namely trimethoxy(propyl)silane (TPS), (3-aminopropyl)trimethoxysilane (APTMS), and trimethoxy(3,3,3-trifluoropropyl)silane (TFP) SAMs, respectively, as shown in the insets of Fig. 1(a)[11]. The untreated IGZO film shows a contact angle of 22.5°, after the treatment, it changes to 55.2° ± 1.7°, 81.9° ± 2.1° and 98.1° ± 2.3° for APTMS, TPS, and TFP treated IGZO films, respectively, suggesting a reduced surface energy. Such a reduced surface energy makes oxygen molecules being difficult to be adsorbed on the surface of the treated IGZO films. As a result, a decrease of both clockwise hysteresis and threshold voltage shift under the positive bias was observed after the treatment with a lowest value of 0.11 ± 0.06 V and 0.32 ± 0.26 V, respectively, achieved in TFP-treated IGZO TFTs (the lowest surface energy case), as shown in Fig. 1(a). Alkyl chain lengths also affect device performance, as reported by Peng et al. who studied the relationship between SAM chain lengths and TFT performance by using triethoxysilane (TES) with three different alkyl chains, namely C1-TES, C8-TES and C18-TES[12]. All treated devices show an increased mobility and a decreased hysteresis compared with the untreated one. Among all treated devices, TFTs treated with C18-TES showed best performance with a mobility of 26.6 cm2/(V·s), which might be due to the formation of a well-ordered and more hydrophobic IGZO surface when treated with SAMs with longer alkyl chains. Similar effects were also reported by Chen et al. in InSnZnO TFTs treated with vapor-phase SAMs[9]. At smaller channel thicknesses, the accumulation layer approaches near the adsorbed water molecules on the top channel surface, inducing a strong carrier scattering and a more pronounced influence of top surface. To study whether the SAM treatment also works in TFTs with a thin channel layer, Song et al. made n-octadecyltrichlorosilane (OTS)-treated IGZO TFTs with different IGZO thicknesses[8]. As shown in Fig. 1(b), even at an IGZO thickness down to 5 nm, the treated devices show a high mobility of 10 cm2/(V·s) with a low subthreshold swing of 64 mV/dec and a high current on/off ratio larger than 106. Also, the device maintains a high performance even after being stored in air for a year (Fig. 1(c)), indicating that the top surface has been effectively passivated. Besides being used as an effective passivation layer on the top surface of oxide TFTs, SAMs can also be applied at the dielectric/channel interface, which affects not only the dynamic performance but also the stability. SAM treatment is now a standard process in organic TFTs to reduce dielectric/channel interface traps and surface energy, but was seldom reported in oxide TFTs due to the potential damage to SAMs. By treating AlOx gate dielectrics with an n-octadecylphosphonic acid (ODPA), Bashir et al. reported high-performance ZnO TFTs made by spray pyrolyzing[13]. To study the survival of ODPA after the high-temperature ZnO deposition, they performed a contact angle measurement, and found that a high contact angle maintained even after a heat treatment of the sample at 400–450 °C in N2 (Fig. 2(a)), demonstrating the high stability of the ultra-thin SAM against heat. The SAM treatment here significantly reduces the gate leakage current, and as a result, the devices show a low operating