Comparison of Ferroelectric Photovoltaic Performance in BFO/BTO Multilayer Thin Film Structure Fabricated Using CSD & PLD Techniques

Savita Sharma,Anjali Sharma,Vinay Gupta,Nitin K. Puri,Monika Tomar

DOI: https://doi.org/10.1007/s11664-021-08793-z

IF: 2.1

2021-03-02

Journal of Electronic Materials

Abstract:Multilayer thin film structures of BFO/BTO possessing a distinct count of layers were prepared by chemical solution deposition and pulsed laser deposition techniques. These two different deposition techniques have been explored to investigate the effect of deposition technique on ferroelectric-photovoltaic properties of the BFO/BTO system in detail. Multilayers prepared using both the techniques exhibit pure perovskite structure showing the tetragonal and rhombohedral phases of BTO/BFO respectively obtained using XRD analysis. The multilayer thin film of BTO/BFO structures possessed enhanced ferroelectric and ferromagnetic properties, which is found to be increasing as the number of layers increases. The maximum values of Ps = 99.80 μC/cm2 and Ms = 94.70 emu/cm3 were obtained for the six-layer system prepared using the PLD technique. The six-layer PLD-grown PV cell upon irradiation with 405-nm wavelength light with 160 mW/cm2 intensity, showed a large increase in photocurrent from 4.5 × 10−7A to 3.84 × 10−4A as compared to the PV cell grown using CSD. The obtained magnitudes of short-circuit photocurrent density (Jsc) and open circuit voltage (Voc) were 0.384 mA/cm2 and − 0.40 individually with 0.098% light-to-electricity conversion efficiency for a six-layer PLD-grown PV cell.

engineering, electrical & electronic,materials science, multidisciplinary,physics, applied