Multifactorial coupling to greatly enhance photocurrent density of BiFeO3-based ferroelectric photovoltaic architectures
Zehao Sun,Jie Wei,Tiantian Yang,Minchuan Xiahou,Ao Cao,Junlong Zhang,Youxin Yuanfeng,Yanchun He
DOI: https://doi.org/10.1007/s10854-024-13786-9
2024-11-07
Journal of Materials Science Materials in Electronics
Abstract:The ferroelectric photovoltaic effect in BiFeO 3 has attracted much attention recently. However, the potential of BiFeO 3 as a photovoltaic material is limited due to its low photocurrent density and consequently low power conversion efficiency. Herein, a novel ferroelectric photovoltaic architecture based on the (Pr, Ni) gradient-doped BiFeO 3 -based thin film coupled with Au nanoparticles layer has been designed and fabricated. The experimental results and analysis show that this photovoltaic architecture exhibits extremely large photocurrent density (5.19 mA/cm 2 ), which is about 472 times larger than that of pure BiFeO 3 film (11 μA/cm 2 ) and about 10 times larger than that of the conventional (Pr, Ni)-doped BiFeO 3 film (0.54 mA/cm 2 ). The enhanced photocurrent density should be attributed to the multifactorial coupling effect in this photovoltaic architecture, including the built-in electric field formed by the gradient distribution of oxygen vacancies, the flexoelectric effect and Local Surface Plasmon Resonance effect of Au nanoparticles.
engineering, electrical & electronic,materials science, multidisciplinary,physics, condensed matter, applied